Jenn-Air W10439669A Installation Requirements, Tools and Parts, Location Requirements

IMPORTANT INSTRUCTIONS:

The Duct Free Filter Accessory Kit is designed to filter the air from the downdraft system and ventilate the conditioned air out into the room through the toe-kick area of the base cabinet. Do not ventilate the air from the downdraft system into the base cabinet, base cabinet pedestal, crawl space, wall or attic.

The Duct Free Filter cartridge is designed for six (6) months of normal cooking activity. The filter cartridge is not designed to be cleaned and reused. The filter must be changed as indicated by the Timestrip®. If the filter is not changed as recommended, the downdraft performance will be reduced.

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools needed

■Tape measure

■Framing square

■Hammer

■Set punch

■Pliers

■Marker or pencil

■Flat-blade screwdriver

■Phillips screwdriver

■Drill

■¼" (6.4 mm) drill bit

■⁷⁄₆₄" (2.8 mm) drill bit

■Jigsaw or keyhole saw

■Masking tape

Parts supplied

■Flow test card

■Poster board template

■Duct free filter housing assembly

■Flex duct

■2 - clamps

■Duct free filter with Timestrip®

■4 - mounting screws

Location Requirements

The Jenn-Air®Duct Free Filter System accessory is approved for use with JED3430, JED3536, JED 4430, JED4546, JGD3430, and JGD3536 series Jenn-Air downdraft products.

The Jenn-Air®Duct Free Filter System accessory is designed to be installed in cabinetry that is constructed to meet Kitchen Cabinet Manufacturers Association (KCMA) requirements for toe- kick space. At a minimum, KCMA toe kick requires a depth dimension of 2½" (6.4 cm) and a height dimension of 3" (7.6 cm) as shown in the following illustration.

	B
A		C

A. Floor

B. 2½" (6.4 cm)

C. 3" (7.6 cm)

The Duct Free Filter

The Jenn-Air®Duct Free Filter System accessory kit includes

1 Duct Free filter cartridge. The filter included with the kit comes with a 6 month Timestrip® sensor preinstalled on the filter. The Timestrip® sensor will be visible after the filter is installed in the filter housing.

After the installation is complete, press the button on the Timestrip® sensor to activate. Once activated, the window of the Timestrip® sensor will darken along the time line until 6 months have elapsed.

A JDA8000WX replacement filter can be obtained by calling

1-800-JENNAIR (1-800-536-6247) or visiting www.jennair.com.

In Canada, call 1-800-807-6777 or visit www.jennair.ca.

2