Poulan PDC18H42STA owner manual To Level Mower Housing, FRONT-TO-BACK Adjustment See Figs

Page 21

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 19 and 20)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Three full turns of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE OF

BOTTOM EDGE OF

MOWER TO GROUND

MOWER TO GROUND

“A”

GROUND LINE

“A”

FIG. 19

SUSPENSION ARM

LIFT LINK ADJUSTMENT NUT

FIG. 20

FRONT-TO-BACK ADJUSTMENT (See Figs. 21 and 22)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its high- est position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjustments, check that both front links are equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns. The two front links must remain equal in length.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

"D"

"D"

FIG. 21

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT "F"

NUT "E"

TRUNNION

FRONT LINKS

FIG. 22

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents PDC18H42STA Safety Rules Safety Rules Table of Contents Steering Wheel Seat Unassembled PartsGauge Wheel Slope SheetTools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CAR- TONAssemble Gauge Wheels to Mower Deck See a Check Battery See FigTo Convert to Bagging or Discharging To SET UP Your Mower for MulchingCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Transport See FigsTowing Carts and Other ATTACH- Ments Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsMulching Mowing Tips Lubrication Chart MaintenanceService Dates General RecommendationsTractor Engine Clean AIR INTAKE/COOLING Areas CleaningMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Check and Adjust Brake See Fig To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig Transaxle Motion Control Lever Neutral Adjustment See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERReplacing Battery See Figs To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb Interlocks and RelaysTo Remove Hood and Grill Assembly See Fig To Adjust Throttle Control Cable See FigTo Adjust Carburetor Other StorageFuel System Engine OILTroubleshooting Points OFF Tractor - Model Number PDC18H42STA, Product no 57 SchematicTractor - Model Number PDC18H42STA, Product no 57 Electrical KEY Part NO. NO. Description 209 208 207 142 212 161 145 KEY Part Description Tractor - Model Number PDC18H42STA, Product no 57 Drive Repair Parts Repair Parts 180656 Wheel Steering Tractor - Model Number PDC18H42STA, Product no 57 Engine KEY Part NO. NO. Description KEY Part Description Wheels & Tires Tractor - Model Number PDC18H42STA, Product no 57 DecalsTractor - Model Number PDC18H42STA, Product no 57 Mower Lift Repair Parts Tractor - Model Number PDC18H42STA, Product no 57 Mower Deck 182032X421 Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PDC18H42STA specifications

The Poulan PDC18H42STA is a robust riding lawn mower designed for homeowners seeking efficiency and reliability in lawn care. Packed with innovative features and advanced technologies, this machine is engineered to make mowing larger lawns a simpler and more enjoyable task.

One of the standout features of the Poulan PDC18H42STA is its powerful 18 HP engine. This reliable engine provides the necessary power to tackle tough grass conditions and uneven terrains, ensuring that the mower operates smoothly without bogging down. The mower's speed is adjustable, allowing users to choose the ideal pace for their specific lawn care needs.

The 42-inch cutting deck is another impressive characteristic of this model. This wide cutting deck enables the Poulan mower to cover large areas efficiently, reducing the overall mowing time. With a three-blade system, the mower offers a clean and even cut, resulting in a beautifully manicured lawn. Additionally, the cutting height is easily adjustable, ranging from one to four inches, allowing for tailored cutting heights based on seasonal conditions and grass types.

A notable technology implemented in the Poulan PDC18H42STA is its ergonomic design, which includes a comfortable high-back seat and a user-friendly control panel. The controls are intuitively positioned, enabling operators to adjust speed, cutting height, and direction with ease. The steering system features a tight turning radius, which is essential for maneuvering around obstacles and making precise turns on the lawn.

Durability is paramount in the construction of the Poulan PDC18H42STA. The mower features a steel frame and a reinforced cutting deck, ensuring longevity and resilience against wear and tear. Furthermore, with its maintenance-free battery and efficient fuel consumption, this mower is designed for prolonged use with minimal upkeep.

Safety is also a critical consideration in the design of the Poulan PDC18H42STA. The mower is equipped with safety features such as an automatic blade brake that engages when the operator leaves the seat, preventing accidents and promoting a safer mowing experience.

In summary, the Poulan PDC18H42STA stands out in the realm of riding lawn mowers with its powerful engine, wide cutting deck, user-friendly design, and durable construction. It combines advanced technologies and features that make lawn care more efficient, giving homeowners a reliable tool for maintaining their outdoor spaces.
Top Page Image Contents