Poulan PD20PH42STA owner manual Cleaning

Page 19

MAINTENANCE

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.

CLEAN AIR INTAKE/COOLING AREAS

To insure proper cooling, make sure the grass screen, cooling fins, and other external surfaces of the engine are kept clean at all times.

Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and other cooling shrouds. Clean the cooling fins and external surfaces as necessary. Make sure the cooling shrouds are reinstalled.

NOTE: Operating the engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will cause engine damage due to overheating.

AIR FILTER (See Fig. 17)

Your engine will not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every 100 hours of operation or every season, whichever occurs first.

Service air cleaner more often under dusty conditions.

•Remove knobs and cover.

TO SERVICE PRE-CLEANER

•Wash it in liquid detergent and water.

•Squeeze it dry in a clean cloth.

•Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil.

•If very dirty or damaged, replace pre-cleaner.

TO SERVICE CARTRIDGE

•Clean cartridge by tapping gently on flat surface. If very dirty or damaged, replace cartridge.

•Reinstall precleaner cartridge, cover and secure with knobs.

IMPORTANT: PETROLEUM SOLVENTS, SUCH AS KEROSENE, ARE NOT TO BE USED TO CLEAN THE CARTRIDGE. THEY MAY CAUSE DETERIORATION OF THE CARTRIDGE. DO NOT OIL CARTRIDGE. DO NOT USE PRESSURIZED AIRTO CLEAN OR DRY CARTRIDGE.

KNOBS

COVER

CARTRIDGE

FOAM

PRE-CLEANER

FIG. 17

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or dam- age.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in “PRODUCT SPECIFICATIONS” section of this manual.

IN-LINE FUEL FILTER (See Fig. 18)

The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carburetor, replacement is required.

•With engine cool, remove filter and plug fuel line sec- tions.

•Place new fuel filter in position in fuel line with arrow pointing towards carburetor.

•Be sure there are no fuel line leaks and clamps are properly positioned.

•Immediately wipe up any spilled gasoline.

CLAMP

CLAMP

 

FUEL

FILTER

FIG. 18

CLEANING

•Clean engine, battery, seat, finish, etc. of all foreign matter.

•Keep finished surfaces and wheels free of all gasoline, oil, etc.

•Protect painted surfaces with automotive type wax.

We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and trans- mission are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves and trash from tractor and mower.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents PD20PH42STA Safety Rules Safety Rules Table of Contents Steering Wheel Seat Unassembled PartsSlope Sheet To Remove Tractor from Carton AssemblyTools Required for Assembly HOW to SET UP Your TractorAssemble Gauge Wheels to Mower Deck See Fig Check Battery See FigCheck Deck Levelness To SET UP Your Mower for MulchingTo Convert to Bagging or Discharging Check Tire PressureOperation Know Your Tractor HOW to USE Your Tractor To Transport See Figs To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on HillsADD Gasoline Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelPurge Transmission Mowing TipsAutomatic Transmission Warm UP Mulching Mowing Tips Before Each USE MaintenanceLubrication Chart General RecommendationsTractor Transaxle Pump Fluid EngineBelts Transaxle CoolingCleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig To Check and Adjust Brake See FigTo Replace Motion Drive Belt See Fig To Remove Wheel for Repairs See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERInterlocks and Relays To Start Engine with a Weak Battery See FigReplacing Battery See Figs To Replace Headlight BulbTo Adjust Carburetor To Remove Hood and Grill Assembly See FigTo Adjust Throttle Control Cable See Fig To Adjust Choke Control See FigEngine OIL StorageOther Fuel SystemTroubleshooting Points With attachment clutch Tractor - Model Number PD20PH42STA Product no 57 SchematicNON-REMOVABLE Connections Removable Electrical KEY Part Description Chassis Tractor - Model Number PD20PH42STA Product no 57 Drive 17670508 Steering Assembly KEY KEY Part NO. NO. Description Seat AssemblyWheels and Tires DecalsEngine 170771 Control, Throttle Mower Deck 182032X421 Mower Lift KEY Part NO. NO. Description Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PD20PH42STA specifications

The Poulan PD20PH42STA is a versatile and powerful lawn tractor designed to meet the needs of homeowners with medium to large lawns. It offers a reliable and efficient solution for cutting grass, making yard maintenance a breeze. This model marries performance with ease of use, incorporating several features and technologies that set it apart in the lawn care market.

One of the standout characteristics of the Poulan PD20PH42STA is its robust engine. It is equipped with a dependable Poulan Pro 20-horsepower engine, which provides ample power for tackling tough lawn conditions. This engine is designed for enhanced fuel efficiency, allowing users to mow larger areas without the need for frequent refueling.

The 42-inch cutting deck is another notable feature of this lawn tractor. This size is ideal for maneuvering through residential lawns while providing sufficient coverage to reduce mowing time. The cutting deck is constructed from durable materials, ensuring longevity and reliability through numerous mowing seasons. Additionally, the deck offers multiple height adjustments, allowing users to achieve their desired grass length, catering to different lawn types and seasonal growth.

Another essential technology integrated into the PD20PH42STA is its hydrostatic transmission. This feature delivers smooth and effortless control, allowing operators to change speeds without the need for shifting gears. As a result, mowing becomes an intuitive experience, enabling the operator to focus on achieving a clean cut rather than managing complex controls.

The design of the Poulan PD20PH42STA prioritizes user comfort and convenience. Its ergonomically designed seat provides ample cushioning, enabling longer mowing sessions without discomfort. The tractor also includes easy-to-reach controls, and an integrated cup holder, ensuring that users can enjoy their mowing time without having to sacrifice comfort.

In terms of maintenance, the design of this lawn tractor makes it relatively simple. For instance, it features an access point for easy oil changes and a removable cutting deck, which simplifies blade maintenance and replacement.

Overall, the Poulan PD20PH42STA is an impressive lawn tractor that combines power, efficiency, and user-friendly features. Whether you’re tackling a large yard or managing overgrown grass, this model is built to deliver exceptional performance, making it a valuable tool for any homeowner looking to maintain a pristine lawn.
Top Page Image Contents