Poulan PD20PH42STA To Start Engine with a Weak Battery See Fig, To Replace Headlight Bulb

Page 24

SERVICE AND ADJUSTMENTS

TO START ENGINE WITH A WEAK BATTERY (See Fig. 28)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

 

02602

 

FIG. 29

TERMINAL

KEPS

COVER

NUT

HEX

BOLT

02603

 

POSITIVE (RED)

NEGATIVE

CABLE

(BLACK) CABLE

 

WEAK OR DEAD BATTERY

02614

FULLY CHARGED

BATTERY

FIG. 30

TO REPLACE HEADLIGHT BULB

•

Raise hood.

• Pull bulb holder out of the hole in the backside of the

 

grill.

•

Replace bulb in holder and push bulb holder securely

 

back into the hole in the backside of the grill.

FIG. 28

REPLACING BATTERY (See Figs. 29 and 30)

WARNING: Do not short battery ter- minals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acci- dental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

• Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PD20PH42STA Safety Rules Safety Rules Table of Contents Unassembled Parts Steering Wheel SeatSlope Sheet Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonCheck Battery See Fig Assemble Gauge Wheels to Mower Deck See FigTo SET UP Your Mower for Mulching To Convert to Bagging or DischargingCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Operate Mower See FigTo Operate on Hills To Transport See FigsBefore Starting the Engine Towing Carts and Other ATTACH- MentsCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionAutomatic Transmission Warm UP Mulching Mowing Tips Maintenance Lubrication ChartGeneral Recommendations Before Each USETractor Engine BeltsTransaxle Cooling Transaxle Pump FluidCleaning Service and Adjustments To Install Mower See FigTo Remove Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Check and Adjust Brake See Fig To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig Transmission REMOVAL/REPLACEMENT To Adjust Steering Wheel ALIGN- MentFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigsTo Replace Headlight Bulb Interlocks and RelaysTo Remove Hood and Grill Assembly See Fig To Adjust Throttle Control Cable See FigTo Adjust Choke Control See Fig To Adjust CarburetorStorage OtherFuel System Engine OILTroubleshooting Points With attachment clutch Schematic Tractor - Model Number PD20PH42STA Product no 57NON-REMOVABLE Connections Removable Electrical KEY Part Description Chassis Tractor - Model Number PD20PH42STA Product no 57 Drive 17670508 Steering Assembly KEY Seat Assembly KEY Part NO. NO. DescriptionDecals Wheels and TiresEngine 170771 Control, Throttle Mower Deck 182032X421 Mower Lift KEY Part NO. NO. Description Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PD20PH42STA specifications

The Poulan PD20PH42STA is a versatile and powerful lawn tractor designed to meet the needs of homeowners with medium to large lawns. It offers a reliable and efficient solution for cutting grass, making yard maintenance a breeze. This model marries performance with ease of use, incorporating several features and technologies that set it apart in the lawn care market.

One of the standout characteristics of the Poulan PD20PH42STA is its robust engine. It is equipped with a dependable Poulan Pro 20-horsepower engine, which provides ample power for tackling tough lawn conditions. This engine is designed for enhanced fuel efficiency, allowing users to mow larger areas without the need for frequent refueling.

The 42-inch cutting deck is another notable feature of this lawn tractor. This size is ideal for maneuvering through residential lawns while providing sufficient coverage to reduce mowing time. The cutting deck is constructed from durable materials, ensuring longevity and reliability through numerous mowing seasons. Additionally, the deck offers multiple height adjustments, allowing users to achieve their desired grass length, catering to different lawn types and seasonal growth.

Another essential technology integrated into the PD20PH42STA is its hydrostatic transmission. This feature delivers smooth and effortless control, allowing operators to change speeds without the need for shifting gears. As a result, mowing becomes an intuitive experience, enabling the operator to focus on achieving a clean cut rather than managing complex controls.

The design of the Poulan PD20PH42STA prioritizes user comfort and convenience. Its ergonomically designed seat provides ample cushioning, enabling longer mowing sessions without discomfort. The tractor also includes easy-to-reach controls, and an integrated cup holder, ensuring that users can enjoy their mowing time without having to sacrifice comfort.

In terms of maintenance, the design of this lawn tractor makes it relatively simple. For instance, it features an access point for easy oil changes and a removable cutting deck, which simplifies blade maintenance and replacement.

Overall, the Poulan PD20PH42STA is an impressive lawn tractor that combines power, efficiency, and user-friendly features. Whether you’re tackling a large yard or managing overgrown grass, this model is built to deliver exceptional performance, making it a valuable tool for any homeowner looking to maintain a pristine lawn.
Top Page Image Contents