Poulan PD20PH42STA owner manual To Level Mower Housing, FRONT-TO-BACK Adjustment See Figs

Page 21

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 20 and 21)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Three full turns of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE OF

BOTTOM EDGE OF

MOWER TO GROUND

MOWER TO GROUND

 

00598

“A”

GROUND LINE

“A”

FIG. 20

SUSPENSION ARM

01553

LIFT LINK ADJUSTMENT NUT

FIG. 21

FRONT-TO-BACK ADJUSTMENT (See Figs. 22 and 23)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its high- est position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjustments, check that both front links are equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns. The two front links must remain equal in length.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

01268

"D"

"D"

FIG. 22

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

01267

NUT "F"

NUT "E"

TRUNNION

FRONT LINKS

FIG. 23

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents PD20PH42STA Safety Rules Safety Rules Table of Contents Unassembled Parts Steering Wheel SeatSlope Sheet Tools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonAssemble Gauge Wheels to Mower Deck See Fig Check Battery See FigTo Convert to Bagging or Discharging To SET UP Your Mower for MulchingCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsTowing Carts and Other ATTACH- Ments Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionAutomatic Transmission Warm UP Mulching Mowing Tips Lubrication Chart MaintenanceGeneral Recommendations Before Each USETractor Belts EngineTransaxle Cooling Transaxle Pump FluidCleaning Service and Adjustments To Install Mower See FigTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Check and Adjust Brake See Fig To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig To Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigReplacing Battery See Figs To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Remove Hood and Grill Assembly See FigTo Adjust Choke Control See Fig To Adjust CarburetorOther StorageFuel System Engine OILTroubleshooting Points With attachment clutch Schematic Tractor - Model Number PD20PH42STA Product no 57NON-REMOVABLE Connections Removable Electrical KEY Part Description Chassis Tractor - Model Number PD20PH42STA Product no 57 Drive 17670508 Steering Assembly KEY KEY Part NO. NO. Description Seat AssemblyWheels and Tires DecalsEngine 170771 Control, Throttle Mower Deck 182032X421 Mower Lift KEY Part NO. NO. Description Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PD20PH42STA specifications

The Poulan PD20PH42STA is a versatile and powerful lawn tractor designed to meet the needs of homeowners with medium to large lawns. It offers a reliable and efficient solution for cutting grass, making yard maintenance a breeze. This model marries performance with ease of use, incorporating several features and technologies that set it apart in the lawn care market.

One of the standout characteristics of the Poulan PD20PH42STA is its robust engine. It is equipped with a dependable Poulan Pro 20-horsepower engine, which provides ample power for tackling tough lawn conditions. This engine is designed for enhanced fuel efficiency, allowing users to mow larger areas without the need for frequent refueling.

The 42-inch cutting deck is another notable feature of this lawn tractor. This size is ideal for maneuvering through residential lawns while providing sufficient coverage to reduce mowing time. The cutting deck is constructed from durable materials, ensuring longevity and reliability through numerous mowing seasons. Additionally, the deck offers multiple height adjustments, allowing users to achieve their desired grass length, catering to different lawn types and seasonal growth.

Another essential technology integrated into the PD20PH42STA is its hydrostatic transmission. This feature delivers smooth and effortless control, allowing operators to change speeds without the need for shifting gears. As a result, mowing becomes an intuitive experience, enabling the operator to focus on achieving a clean cut rather than managing complex controls.

The design of the Poulan PD20PH42STA prioritizes user comfort and convenience. Its ergonomically designed seat provides ample cushioning, enabling longer mowing sessions without discomfort. The tractor also includes easy-to-reach controls, and an integrated cup holder, ensuring that users can enjoy their mowing time without having to sacrifice comfort.

In terms of maintenance, the design of this lawn tractor makes it relatively simple. For instance, it features an access point for easy oil changes and a removable cutting deck, which simplifies blade maintenance and replacement.

Overall, the Poulan PD20PH42STA is an impressive lawn tractor that combines power, efficiency, and user-friendly features. Whether you’re tackling a large yard or managing overgrown grass, this model is built to deliver exceptional performance, making it a valuable tool for any homeowner looking to maintain a pristine lawn.
Top Page Image Contents