Poulan 433723, 96042012000 manual Transmission

Page 23

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 38)

WARNING: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

 

 

02602

TERMINAL

NUT

COVER

 

 

 

BOLT

POSITIVE

 

NEGATIVE

(RED)

02603

CABLE

 

(BLACK)

 

 

CABLE

Fig. 38

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 39)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR



Fig. 39

TRANSMISSION

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and beforeoperating thetractor. See “PURGE TRANSMISSION” in the Operation section of this manual.

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engine manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents PB195H42LT II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Steering Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Deck Levelness To Adjust Seat See FigCheck Tire Pressure Operation Position Know Your TractorROS on To USE Throttle Control See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig Reverse Operation System ROSCheck Engine OIL Level Before Starting the EngineTo Operate on Hills Towing Carts and Other AttachmentsAutomatic Transmission Warm UP Mowing TipsPurge Transmission Schedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Engine Muffler Clean AIR ScreenCleaning AIR FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel AlignmentTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingTroubleshooting Points Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimited Warranty

433723, 96042012000 specifications

The Poulan 96042012000,433723 is a robust and versatile gas-powered chainsaw designed for both casual users and professional woodworkers. Featuring a powerful engine, this chainsaw is capable of handling a variety of cutting tasks, making it an excellent choice for homeowners and landscapers alike.

One of the standout features of the Poulan 96042012000,433723 is its 42cc 2-cycle engine. This engine is engineered to deliver the perfect balance of power and efficiency, ensuring that you can tackle heavy-duty cutting jobs without overexerting yourself. The chainsaw boasts an impressive bar length commonly around 16 to 18 inches, enabling users to cut through thick branches and logs with ease.

The chainsaw also incorporates advanced technologies that enhance both performance and user experience. One of these technologies is the powerful cooling system, which helps maintain optimal operating temperatures during prolonged use. This feature not only extends the life of the engine but also ensures consistent cutting performance.

Moreover, the Poulan 96042012000,433723 features an automatic oiling system, allowing for effective lubrication of the chain and bar. This system helps to minimize friction, reducing wear and tear on the components, which leads to lower maintenance needs and a longer lifespan for the tool.

User comfort is also a priority in the design of this chainsaw. The ergonomically designed handle provides a secure grip, reducing fatigue during extended use. Coupled with the lightweight construction of the chainsaw, it becomes easy to maneuver, allowing for precise cutting and control in various applications.

Safety is another critical aspect of the Poulan 96042012000,433723. It includes features such as a chain brake for quick stopping power and a low kickback chain, which minimizes the risk of accidents. These safety enhancements make it suitable for users of all skill levels.

In conclusion, the Poulan 96042012000,433723 is a powerful, efficient, and user-friendly chainsaw that is ideal for a wide range of cutting tasks. With its robust engine, advanced technologies, and safety features, it stands out as a reliable tool for both personal and professional use in maintaining and managing outdoor spaces.
Top Page Image Contents