Poulan 96012010200, 433471 manual To Level Mower Housing, FRONT-TO-BACK Adjustment See Figs

Page 20

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See the sides of the tires for proper PSI). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 13 and 14)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

 

BOTTOM EDGE

OF MOWER TO

 

OF MOWER TO

GROUND

 

GROUND

A

GROUND LINE

A

FIG. 13

SUSPENSION ARM

LIFT LINK

ADJUSTMENT NUT

FIG. 14

FRONT-TO-BACK ADJUSTMENT (See Figs. 15 and 16)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its high- est position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjustments, check that both front links are equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns. The two front links must remain equal in length.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

“D”

“D”

FIG. 15

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT “F”

NUT “E”

TRUNNION

FRONT LINKS

FIG. 16

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents PO17542LT ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Steering WheelAssembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidTo Check Battery See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Operate Mower See FigTo Operate on Hills To TransportBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleTractor Blade Removal See FigBattery Transaxle MaintenanceEngine BeltsCleaning Clean AIR ScreenAIR Filter MufflerTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Drive Belt See FigTransaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionExcessive Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

433471, 96012010200 specifications

The Poulan 96012010200,433471 is a robust and reliable chainsaw designed for both professional landscapers and diligent homeowners. Known for its powerful performance, this chainsaw stands out due to its combination of advanced technology and user-friendly features, making it suitable for a variety of cutting tasks.

One of the key features of the Poulan 96012010200,433471 is its potent engine. With a highly efficient two-stroke design, it delivers ample power to tackle even the toughest jobs. This allows the chainsaw to cut through thick branches and trees with ease, ensuring quick and efficient results. Additionally, the engine's design aids in reducing emissions and noise, making it an environmentally friendly choice for users who are conscious of their carbon footprint.

The chainsaw’s ergonomic design is another significant highlight. Weighing in at a manageable level, it provides an optimal balance for ease of maneuverability during operation. The handle is designed with comfort in mind, featuring anti-vibration technology to reduce fatigue and ensure stability while cutting. This thoughtful ergonomics allows users to maintain control over long working sessions without straining their hands or arms.

Another characteristic that makes the Poulan 96012010200,433471 exceptional is its ease of use. The chainsaw comes equipped with a tool-less chain tensioning system, allowing users to adjust the chain quickly and efficiently without the need for special tools. This feature is particularly beneficial for those who might encounter unexpected situations in the field, ensuring downtime is minimized.

Safety features also prioritize the user's well-being. The chainsaw includes a chain brake that activates in the event of kickback, providing immediate stopping action. Furthermore, the throttle lock prevents accidental acceleration, which can help prevent accidents during operation.

Users will appreciate the chainsaw's durable construction, made from high-quality materials designed to withstand wear and tear over time. The Poulan 96012010200,433471 is built not just for performance, but also for longevity. With its combination of power, comfort, and safety features, this chainsaw is an excellent choice for anyone looking to invest in a reliable piece of outdoor equipment that promises to deliver exceptional results in their cutting tasks.
Top Page Image Contents