Poulan 96042003501, 413437 manual To Level Mower

Page 22

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 20)

•With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower.

•With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower LH side of mower, or, to the right to raise LH side of mower.

 

A

Turn nut right

Turn nut left

to raise mower

to lower mower

02948

 

FIG. 20

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

•Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 21)

•With all tires properly inflated, park tractor on level ground or driveway.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to its highest position.

•At both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides.

 

02966

A

A

FIG. 21

•If adjustment is necessary, see step in Visual Adjust- ment instructions above.

•Recheck measurements, adjust if necessary until both sides are equal.

FRONT-TO-BACK ADJUSTMENT (See Figs. 22 and 23) IMPORTANT: Deck must be level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to highest position.

•Position any blade so the tip is pointing straight forward. Measure distance (B) to the ground at front and rear tip of the blade.

•If front tip of blade is not 1/8" to 1/2" lower than the rear

02548

BB

FIG. 22

tip, go to the front of tractor.

•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.

•With a 3/4" or adjustable wrench, turn front link adjust- ment nut (B) clockwise (ltighten) to raise the front of mower, or, counterclockwise (loosen) to lower the front mower.

B

A

Tighten adjust nut

Loosen adjust

B to raise mower

nut B to lower

02950

mower

 

Loosen jam nut A first

FIG. 23

NOTE: Each full turn of the adjustment nut will change mower height about 1/8".

•Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lower than the rear tip.

•Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents PB19546LT ModelGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation III. Children ServiceIV. Towing Table of Contents Contents of Hardware Pack Before Removing Tractor from Skid Tools Required for AssemblyTo Remove Tractor from Carton Unpack CartonInstall Seat See Figs Check Battery See FigCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Reverse Operation System ROSTo Operate on Hills Towing Carts and Other ATTACH- Ments Before Starting the EngineTo Transport ADD GasolineMowing Tips General Recommendations MaintenanceLubrication Chart ScheduleCheck Operator Presence System TractorBlade Removal See Fig Check Reverse Operation ROS SystemTo Sharpen Blade See Fig BatteryTo Clean Battery and Terminals BeltsLubrication EngineTo Change Engine OIL see Figs Cleaning To Install Mower See Fig To Remove Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Check Brake Belt InstallationTo Replace Mower Drive Belt See Fig To Replace Motion Belt Drive See FigTo Adjust Steering Wheel ALIGN- Ment Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbEngine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionEngine dies when Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopePage Page Degrés Suivant LES UNE Pliez EST CeciDépannage DE Guide Défectueux estRalenti Entreposage Réglages ET Révision MoteurAVANT/ Roues DES Convergence Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourCarrossage 26 .FigFreins LES Vérifier Pour Courroie Acer Rempl Pour’ENTRAÎNEMENT 25 .FIG22 .FIG Tondeuse LA Niveau LE Ajuster Pour23 .FIG 21 .FIG17 .FIG 19 .FIG18 .FIG 16 .FIGFigs Voir D’ENTRAÎNEMENT Fig Voir Courroie LA ET Tondeuse LA InstallerReglages ET Revision Tondeuse LA Enlever PourEntretien 13 .FIG 12 ET 11 .FIGS LES Voir Moteur DE L’HUILE Changer PourLubrification 12 .FIGTrapézoïdales Courroies Transmission LA DE RefroidissementFig la Voir Lame LA Affiler Bornes LES ET Batterie LA Nettoyer PourLames DES Entretien Fig la Voir Lame LA EnleverEN Fonctionnement DE Système ET Lubrification DE Tableau O I T a D N a M M O C E RUtilisation Chaque Avant Moteur LE Démarrer Pour UtilisationTonte DE Conseils DisengagedMoteur DU D’HUILE Niveau LE Vérifier Accessoires Autres’ESSENCE Réservoir LE Remplir ET Charrettes DES Remorquer PourTondeuse DE Lames LES Arrêter Pour Tondeuse LA Utiliser PourArrière Marche EN Fonctionnement GEDFig la Voir Mentne GAZ DES Commande LA Utiliser PourFig la Voir Arrêter Pour Tionsta DE Frein LE Engager PourDattachement Propriété la de lendommagement Toutes SI Vérifier Toutes SI Vérifier MontageCorrectement Sont Courroies LES PA LA DE Tracteur LE Retirer PourConnaître pour mentnetionfonc tionsec la DesmanCom des fonction la et mentceplalem Fig la Voir Batterie LA VérifierTionrecdi DE Volant LE Fixer DU Tracteur LE Sortir PourPour Exigés Outils LES Carton LE DeballerMontar SIN Piezas 28-27 Dépannage DE Guide Sommaire25-20 Réglages ET Révision ’utilisation pour Conseils Général EntretienTracteurs des sécurité toute ’ESSENCE DE Sûre ManipulationLES Dans Fonctionnement PentesTracteurs des sécurité toute en l’utilisation pour Conseils AUX Imprimé

413437, 96042003501 specifications

The Poulan 96042003501,413437 is a robust and versatile lawn mower that combines power, efficiency, and user-friendly features to cater to various lawn care needs. Designed for residential use, this model stands out due to its reliable performance and innovative technologies that enhance both functionality and convenience for homeowners.

One of the key features of the Poulan 96042003501,413437 is its powerful engine. Equipped with a reliable gas engine, it offers sufficient horsepower to tackle dense and overgrown grass, ensuring a clean and even cut every time. The engine starts easily, allowing users to get right to work without any delays. The mower's design also includes a solid cutting deck, which not only provides a wide cutting path for faster mowing but is also durable enough to withstand the rigors of regular use.

Another important feature of this model is its adjustable cutting height. Users can customize the height of the mower blades, making it easy to achieve the desired grass length based on individual lawn requirements and seasonal changes. This flexibility is essential for maintaining a healthy and aesthetically pleasing lawn.

The Poulan 96042003501,413437 also incorporates advanced mulching technology, allowing users to finely chop grass clippings and redistribute them back onto the lawn. This not only saves time by eliminating the need for bagging but also contributes to the lawn's health by returning valuable nutrients to the soil.

Safety features are paramount in the design of the Poulan mower. It includes a safety blade brake that halts the blades' rotation when the user disengages the control handle, preventing any accidental injuries. The mower is also equipped with ergonomic handles that ensure a comfortable grip, reducing fatigue during extended mowing sessions.

In terms of maintenance, the Poulan 96042003501,413437 is designed for easy access to critical components, facilitating routine checks and servicing. This ensures that the mower remains in optimal working condition over time.

Overall, the Poulan 96042003501,413437 is an efficient lawn care solution that combines power, versatility, safety, and ease of maintenance, making it an excellent choice for homeowners looking to maintain their lawns with minimal effort and maximum results. With its thoughtful design and innovative features, it stands as a reliable tool for achieving a beautifully manicured lawn.
Top Page Image Contents