Poulan 413437, 96042003501 manual To Replace Mower Drive Belt See Fig, To Check Brake, Belt Removal

Page 23

SERVICE AND ADJUSTMENTS

To Replace Mower Drive Belt (See Fig. 24)

MOWER DRIVE BELT REMOVAL

1.Park tractor on a level surface. Engage parking brake.

2.Lower attachment lift lever to its lowest position.

4.Remove any dirt or grass clippings which may have accumulated around mandrels and entire upper deck surface.

5.Remove belt from clutch pulley (M), both mandrel pul- leys (R) and all idler pulleys (S).

MOWER DRIVE BELT INSTALLATION

1.Install belt around both mandrel pulleys (R) and around idler pulleys (S) as shown.

2.Install belt onto clutch pulley (M).

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

3. Raise attachment lift lever to highest position.

'

-

&

12

'

! %

"

0

#

+

,$

FIG. 24

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

•Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

•Place gear shift lever in neutral (N) position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

TO REPLACE MOTION BELT DRIVE (See Fig. 25)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

•Remove mower (See “TO REMOVE MOWER” in this section of manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

•Remove belt from stationary idler (A) and clutching idler (B).

•Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (D).

•Remove belt downward from engine pulley (E).

•Slide belt toward rear of tractor, off the steering plate

(F) and remove from tractor.

BELT INSTALLATION -

•Install new belt from tractor rear to front, over the steer- ing plate (F) and above clutch brake pedal shaft (G).

•Pull belt toward front of tractor and roll belt onto engine pulley (E).

•Pull belt toward rear of tractor. Carefully work belt down around transmission cooling fan and onto the input pulley (D). Be sure belt is inside the belt keeper.

•Install belt through stationary idler (A) and clutching idler (B).

•Make sure belt is in all pulley grooves and inside all belt guides and keepers.

•Install mower (See “TO INSTALL MOWER” in this section of manual).

E

F

A

G

B

D

02954

Manual

FIG. 25

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Model PB19546LTII. Slope Operation Safe Operation Practices for Ride-On MowersGeneral Operation IV. Towing ServiceIII. Children Table of Contents Contents of Hardware Pack Unpack Carton Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Install Seat See FigsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Reverse Operation System ROSTo Operate Mower See Fig ADD Gasoline Before Starting the EngineTo Transport Towing Carts and Other ATTACH- MentsMowing Tips Schedule MaintenanceLubrication Chart General RecommendationsCheck Reverse Operation ROS System TractorBlade Removal See Fig Check Operator Presence SystemBelts BatteryTo Clean Battery and Terminals To Sharpen Blade See FigTo Change Engine OIL see Figs EngineLubrication Cleaning To Remove Mower See Fig To Install Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Belt Drive See Fig Belt InstallationTo Replace Mower Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel ALIGN- MentTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorCylinders OtherFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXPage Page UNE Pliez EST Ceci Degrés Suivant LESDéfectueux est Dépannage DE GuideRalenti Entreposage Moteur Réglages ET Révision26 .Fig Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourCarrossage AVANT/ Roues DES Convergence25 .FIG Courroie Acer Rempl Pour’ENTRAÎNEMENT Freins LES Vérifier Pour21 .FIG Tondeuse LA Niveau LE Ajuster Pour23 .FIG 22 .FIG16 .FIG 19 .FIG18 .FIG 17 .FIGTondeuse LA Enlever Pour Courroie LA ET Tondeuse LA InstallerReglages ET Revision Figs Voir D’ENTRAÎNEMENT Fig VoirEntretien 12 .FIG 12 ET 11 .FIGS LES Voir Moteur DE L’HUILE Changer PourLubrification 13 .FIGBornes LES ET Batterie LA Nettoyer Pour Transmission LA DE RefroidissementFig la Voir Lame LA Affiler Trapézoïdales CourroiesEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverLames DES Entretien Utilisation Chaque Avant O I T a D N a M M O C E RLubrification DE Tableau Disengaged UtilisationTonte DE Conseils Moteur LE Démarrer PourET Charrettes DES Remorquer Pour Accessoires Autres’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierGED Tondeuse LA Utiliser PourArrière Marche EN Fonctionnement Tondeuse DE Lames LES Arrêter PourTionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourFig la Voir Arrêter Pour Fig la Voir MentneDattachement Propriété la de lendommagement PA LA DE Tracteur LE Retirer Pour MontageCorrectement Sont Courroies LES Toutes SI Vérifier Toutes SI VérifierFig la Voir Batterie LA Vérifier DesmanCom des fonction la et mentceplalem Connaître pour mentnetionfonc tionsec laCarton LE Deballer DU Tracteur LE Sortir PourPour Exigés Outils LES Tionrecdi DE Volant LE FixerMontar SIN Piezas 25-20 Réglages ET Révision Sommaire28-27 Dépannage DE Guide ’ESSENCE DE Sûre Manipulation Général EntretienTracteurs des sécurité toute ’utilisation pour ConseilsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement AUX Imprimé

413437, 96042003501 specifications

The Poulan 96042003501,413437 is a robust and versatile lawn mower that combines power, efficiency, and user-friendly features to cater to various lawn care needs. Designed for residential use, this model stands out due to its reliable performance and innovative technologies that enhance both functionality and convenience for homeowners.

One of the key features of the Poulan 96042003501,413437 is its powerful engine. Equipped with a reliable gas engine, it offers sufficient horsepower to tackle dense and overgrown grass, ensuring a clean and even cut every time. The engine starts easily, allowing users to get right to work without any delays. The mower's design also includes a solid cutting deck, which not only provides a wide cutting path for faster mowing but is also durable enough to withstand the rigors of regular use.

Another important feature of this model is its adjustable cutting height. Users can customize the height of the mower blades, making it easy to achieve the desired grass length based on individual lawn requirements and seasonal changes. This flexibility is essential for maintaining a healthy and aesthetically pleasing lawn.

The Poulan 96042003501,413437 also incorporates advanced mulching technology, allowing users to finely chop grass clippings and redistribute them back onto the lawn. This not only saves time by eliminating the need for bagging but also contributes to the lawn's health by returning valuable nutrients to the soil.

Safety features are paramount in the design of the Poulan mower. It includes a safety blade brake that halts the blades' rotation when the user disengages the control handle, preventing any accidental injuries. The mower is also equipped with ergonomic handles that ensure a comfortable grip, reducing fatigue during extended mowing sessions.

In terms of maintenance, the Poulan 96042003501,413437 is designed for easy access to critical components, facilitating routine checks and servicing. This ensures that the mower remains in optimal working condition over time.

Overall, the Poulan 96042003501,413437 is an efficient lawn care solution that combines power, versatility, safety, and ease of maintenance, making it an excellent choice for homeowners looking to maintain their lawns with minimal effort and maximum results. With its thoughtful design and innovative features, it stands as a reliable tool for achieving a beautifully manicured lawn.
Top Page Image Contents