Poulan 414754, 96012006802 manual To Remove Mower See Fig, To Install Mower See Fig

Page 19
SMALL RETAINER SPRING

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

Depress clutch/brake pedal fully and set parking brake.

Place gearshift lever in neutral (N) position.

Place attachment clutch in “DISENGAGED” position.

Turn ignition key to “STOP” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 13)

Mower will be easier to remove from the right side of trac- tor.

Place attachment clutch in “DISENGAGED” position.

Move attachment lift lever forward to lower mower to its lowest position.

Roll belt off engine pulley.

Remove small retainer spring, and remove clutch spring off pulley bolt.

Remove large retainer spring, slide collar off and push housing guide out of bracket.

Disconnect anti-swaybar from chassis bracket by re- moving retainer spring.

Disconnect suspension arms from rear deck brackets by removing retainer springs.

Disconnect front links from deck by removing retainer springs.

Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS AND HOOK THE CLUTCH SPRING INTO SQUARE HOLE IN FRAME.

CLUTCH SPRING

FLAT WASHER

SMALL RETAINER SPRING

CLUTCH SPRING

RETAINER SPRING

ANTI-SWAY BAR

COLLAR

HOUSING

BRACKET

GUIDE

TO INSTALL MOWER (See Fig. 13)

Raise attachment lift lever to its highest position.

Slide mower under tractor with deflector shield to right side of tractor.

Lower lift lever to its lowest position.

Connect front links to mower deck and secure with retainer springs..

Connect suspension arms to rear deck brackets and secure with retainer springs.

Connect anti-swaybar to chassis bracket and secure with retainer spring.

Push clutch cable housing guide into bracket, slide col- lar onto guide and secure with large retainer spring.

Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.

Make sure belt is inside the belt keeper at the idler and on both sides of the wire belt keeper as shown.

Install belt onto engine pulley.

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

SQUARE HOLE

SUSPENSION

ENGINE PULLEY

ARMS

 

 

FRONT LINK

RETAINER SPRINGS (BOTH SIDES)

DEFLECTOR

SHIELD

96 6 02

LARGE

 

RETAINER

FIG. 13

SPRING

19

Image 19
Contents Model PO15542LTGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation IV. Towing ServiceGeneral Service III. ChildrenTable of Contents Unassembled Parts Unpack Carton Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Install Seat See FigCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Transport Reverse Operation System ROSTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Lubrication Chart MaintenanceBlade Removal See Fig TractorTo Sharpen Blade See Fig Transaxle Cooling BatteryEngine BeltsMuffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig To Install Mower See FigFRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel ALIGN- MentTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorCylinders OtherFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LESDentretien Remarques Limitée Garantie Correction Cause Problème Dépannage DE GuideRalenti Moteur EntreposageRéglages ET Révision Vitesses DE Boîte LA DE Mentgechan CarrossageAVANT/ Roues DES Convergence DI LA DE L’ALIGNEMENT Régler PourTransmission DE MENTNETRAÎD’EN Courroie LA Remplacer PourTondeuse DE Lame DE Mentnetraî ’EN Courroie LA Remplacer PourLautre À Côté DUN Réglage DE Boîtier LE Niveau DE Mettre PourSedeuton Larrière À Devant DU RéglageReglages ET Revision Tondeuse LA Installer PourTondeuse LA Enlever Pour AIR À Filtre Ligne EN Installé D’ESSENCE FiltreEntretien ’ALLUMAGE BougieMoteur DE L’HUILE Changer Pour LubrificationTransmission LA DE Refroidissement Trapézoïdales CourroiesFig la Voir Lame LA Enlever Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Utilisation Chaque Avant Recommandations LESGénérales Lubrification DE TableauTonte DE Conseils UtilisationMoteur DU D’HUILE Niveau LE Vérifier Moteur LE Démarrer DE AvantMoteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirPentes LES Dans Utiliser Pour Accessoires AutresET Charrettes DES Remorquer Pour Tracteur LE Transporter PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourTeurtrac E R T O V R E S I L I T U T N E M M O C Fig la Voir Arrêter Pour02829 Moteur Montage LA Voir Rouler Faisant LE EN Ette LA DE Tracteur LE Retirer PourDesmancom DES CON Pour Mentnetionfonc TionsecToncar DU Tracteur LE Sortir PourLE Pour Exigés Outils LES Palette LA DE Tracteur LE Retirer DE AvantClés Montar SIN PiezasClient DU Responsabilités SommaireProduit DE Spécifications Général Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement Général FonctionnementAUX Imprimé Com.poulan.www web site notre Visitez

414754, 96012006802 specifications

The Poulan 96012006802, 414754 is a versatile lawn maintenance tool designed for both homeowners and professional landscapers who demand efficiency and precision in their outdoor tasks. This powerful equipment combines advanced technology with robust construction to cater to various cutting needs.

One of the standout features of the Poulan 96012006802, 414754 is its powerful engine, which ensures reliable performance and longevity. This model is equipped with a patented 2-cycle engine that delivers not only ample power but also enhances fuel efficiency, allowing users to complete tasks without the constant need for refueling. This engine design minimizes the effort necessary to tackle thick grass and tough weeds, making it ideal for bigger yards or commercial applications.

Another significant characteristic of the Poulan 96012006802, 414754 is its lightweight design. Weighing less than many comparable models, it minimizes user fatigue during extended periods of operation. This is particularly beneficial for those who have larger lawns or are involved in extensive landscaping work. The ergonomic handle provides a comfortable grip, allowing for better maneuverability and control, reducing strain on the hands and arms.

The cutting mechanism of the Poulan 96012006802, 414754 is noteworthy for its efficiency. It is designed with a durable cutting blade that can handle a variety of grass types and thicknesses. The adjustable cutting height feature allows users to select their preferred grass length, creating a custom lawn aesthetic while promoting healthy growth.

Furthermore, this model incorporates safety features that enhance user protection. A throttle control system ensures that the engine revs are optimized for various tasks, while also providing an easy way to shut off the power immediately when needed.

In summary, the Poulan 96012006802, 414754 presents an excellent option for those seeking a reliable, powerful, and user-friendly lawn maintenance tool. With its efficient engine, lightweight design, adjustable cutting height, and enhanced safety features, it stands out in the competitive landscape of gardening equipment. Whether for residential upkeep or professional landscaping projects, this model promises to deliver exceptional performance and results.