Poulan 414754 manual To Replace Mower Blade Drive Belt See Fig, To Check Brake, Belt Removal

Page 21

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 18)

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

Place attachment clutch in “DISENGAGED” position.

Move attachment lift lever forward to lower mower to its lowest position.

Roll belt off engine pulley.

Work belt off both mandrel pulleys and idler pulleys.

Pull belt away from mower.

BELT INSTALLATION -

Work new belt around both mandrel pulleys and idler pulleys.

Install new belt into engine pulley groove.

Make sure belt is inside the belt keeper at the idler and on both sides of the wire belt keeper as shown.

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

IDLER

PULLEYS

MANDREL

PULLEY

MANDREL

PULLEY

FIG. 18

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress clutch/brake pedal all the way down and en- gage parking brake.

2.Place gear shift lever in neutral (N) position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

TO REPLACE MOTION DRIVE BELT (See Fig. 20)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

Remove mower (See “TO REMOVE MOWER” in this section of manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

Remove belt from stationary idler and clutching idler.

Remove belt downward from around engine pulley.

Pull belt slack toward rear of tractor. Remove belt upwards from transaxle pulley by deflecting belt keep- ers.

Remove belt from center span keeper and pull belt away from tractor.

BELT INSTALLATION -

Carefully work new belt down between transaxle belt keepers and onto the input pulley.

Slide belt into the center span keeper.

Pull belt toward front of tractor and roll around the top groove of engine pulley.

Install belt through stationary idler and clutching idler.

Make sure belt is in all pulley grooves and inside all belt guides and keepers.

Install mower (See “TO INSTALL MOWER” in this sec- tion of manual).

ENGINE

PULLEY

CLUTCHING

IDLER

STATIONARY

IDLER

CENTER SPAN

KEEPER

TRANSAXLE

PULLEY

FIG. 20

21

Image 21
Contents Model PO15542LTSafe Operation Practices for Ride-On Mowers General OperationII. Slope Operation General Service ServiceIII. Children IV. TowingTable of Contents Unassembled Parts To Remove Tractor from Carton Tools Required for AssemblyBefore Removing Tractor from Skid Unpack CartonCheck Battery See Fig Install Seat See FigCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Reverse Operation System ROSTo Operate on Hills To TransportCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMowing Tips Lubrication Chart MaintenanceTractor Blade Removal See FigTo Sharpen Blade See Fig Engine BatteryBelts Transaxle CoolingClean AIR Screen CleaningAIR Filter MufflerTo Remove Mower See Fig To Install Mower See FigFRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt InstallationTo Check Brake To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbFuel System OtherEngine OIL CylindersProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LESDentretien Remarques Limitée Garantie Correction Cause Problème Dépannage DE GuideRalenti Moteur EntreposageRéglages ET Révision AVANT/ Roues DES Convergence CarrossageDI LA DE L’ALIGNEMENT Régler Pour Vitesses DE Boîte LA DE MentgechanTondeuse DE Lame DE Mentnetraî Courroie LA Remplacer Pour’EN Courroie LA Remplacer Pour Transmission DE MENTNETRAÎD’ENSedeuton DE Boîtier LE Niveau DE Mettre PourLarrière À Devant DU Réglage Lautre À Côté DUN RéglageTondeuse LA Installer Pour Reglages ET RevisionTondeuse LA Enlever Pour Entretien Ligne EN Installé D’ESSENCE Filtre’ALLUMAGE Bougie AIR À FiltreTransmission LA DE Refroidissement LubrificationTrapézoïdales Courroies Moteur DE L’HUILE Changer PourFig la Voir Lame LA Affiler Fig la Voir Lame LA EnleverEN Fonctionnement DE Système ET Générales Recommandations LESLubrification DE Tableau Utilisation Chaque AvantTonte DE Conseils UtilisationMoteur LE Démarrer Pour Moteur LE Démarrer DE Avant’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierET Charrettes DES Remorquer Pour Accessoires AutresTracteur LE Transporter Pour Pentes LES Dans Utiliser PourTeurtrac E R T O V R E S I L I T U T N E M M O C GAZ DES Commande LA Utiliser PourFig la Voir Arrêter Pour Fig la Voir Mentnetionsta DE Frein LE Engager Pour02829 Moteur Montage Desmancom DES LA DE Tracteur LE Retirer PourCON Pour Mentnetionfonc Tionsec LA Voir Rouler Faisant LE EN EtteLE Pour Exigés Outils LES DU Tracteur LE Sortir PourPalette LA DE Tracteur LE Retirer DE Avant ToncarClés Montar SIN PiezasSommaire Client DU ResponsabilitésProduit DE Spécifications Remorquage EntretienEnfants Général EntretienLES Dans Fonctionnement PentesGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé Com.poulan.www web site notre Visitez

414754, 96012006802 specifications

The Poulan 96012006802, 414754 is a versatile lawn maintenance tool designed for both homeowners and professional landscapers who demand efficiency and precision in their outdoor tasks. This powerful equipment combines advanced technology with robust construction to cater to various cutting needs.

One of the standout features of the Poulan 96012006802, 414754 is its powerful engine, which ensures reliable performance and longevity. This model is equipped with a patented 2-cycle engine that delivers not only ample power but also enhances fuel efficiency, allowing users to complete tasks without the constant need for refueling. This engine design minimizes the effort necessary to tackle thick grass and tough weeds, making it ideal for bigger yards or commercial applications.

Another significant characteristic of the Poulan 96012006802, 414754 is its lightweight design. Weighing less than many comparable models, it minimizes user fatigue during extended periods of operation. This is particularly beneficial for those who have larger lawns or are involved in extensive landscaping work. The ergonomic handle provides a comfortable grip, allowing for better maneuverability and control, reducing strain on the hands and arms.

The cutting mechanism of the Poulan 96012006802, 414754 is noteworthy for its efficiency. It is designed with a durable cutting blade that can handle a variety of grass types and thicknesses. The adjustable cutting height feature allows users to select their preferred grass length, creating a custom lawn aesthetic while promoting healthy growth.

Furthermore, this model incorporates safety features that enhance user protection. A throttle control system ensures that the engine revs are optimized for various tasks, while also providing an easy way to shut off the power immediately when needed.

In summary, the Poulan 96012006802, 414754 presents an excellent option for those seeking a reliable, powerful, and user-friendly lawn maintenance tool. With its efficient engine, lightweight design, adjustable cutting height, and enhanced safety features, it stands out in the competitive landscape of gardening equipment. Whether for residential upkeep or professional landscaping projects, this model promises to deliver exceptional performance and results.