Poulan 418791 manual Before Starting the Engine, To Transport See Figs, Check Engine OIL Level

Page 13

OPERATION

TO TRANSPORT (See Figs. 4 and 8)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

Raise attachment lift to highest position with attachment lift control.

Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

Transmission Engaged

02219

Transmission Disengaged

FIG. 8

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 4)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Be sure freewheel control is in the transmission engaged position.

Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

Place motion control lever in neutral (N) position.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

When engine starts, move the throttle control to the fast position.

13

Image 13
Contents Model PB195H42LTXSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Steering Wheel Unassembled PartsSeat Keys Slope SheetTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Install Seat See FigCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS See Fig To Operate Mower See FigTo Operate on Hills To Transport See Figs Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP RunningLubrication Chart MaintenanceBlade Removal See Fig TractorTo Sharpen Blade See Fig Check Operator Presence SystemEngine Lubrication BatteryTransaxle Pump Fluid BeltsClean AIR Screen CleaningAIR Filter MufflerTo Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal Transaxle Motion Control Lever Neutral Adjustment See Fig To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when HOP Outdoor Products Customer Service DeptCanada contact Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAService Notes Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LESDentretien Notes Autorisé Dept Service Customer Products Outdoor Canada AuGarantie cette de exclus sont normal l’entretien et Conducteur le lorsque Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Moteur EntreposageTracteur Moteur Reglages ET RevisionRossage LA DE ENLEVEMENT/REMPLACEMENTAVANT/CAR Roues DES Convergence LA DE L’ALIGNEMENT Régler Pour’EN Courroie LA Remplacer Pour Fig la VoirFrein LE Régler ET Contrôler Pour Transmission DE MentnetraîTondeuse DE Lame DE MENTNETRAÎD’EN Courroie Acer Rempl Pour15 .FIG Tondeuse DE Boîtier LE Niveler Pour’ALLUMAGE Bougie EntretienAIR À Filtre ’AIR Tamis LE NettoyerTransmission LA DE Refroidissement Sionmistrans LA DE Moteur FluideFig la Voir Lame LA Affiler Trapézoïdales CourroiesEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverGénérales Recommandations LESLubrification DE Tableau Utilisation Chaque AvantTondre DE Conseils UtilisationTransmission LA Purger QuetiMoteur LE Démarrer DE Avant Tracteur LE Transporter Pour Et 4 .Fig les VoirPentes LES Dans Utiliser Pour Tondeuse LA Utiliser PourTeurtrac Votre Utiliser Comment GAZ DES Commande LA Utiliser PourFig la Voir Arrêter Pour Fig la Voir Mentnetionsta DE Frein LE Engager PourLSW02838 ’EMBRAYAGE NI DE EST Tondeuse LA SI Vérifier MontageDesmancom des tionfonc la et Tionsec la Voir Conduisant LE EN TeletVotre Monter Comment Fig la Voir Siège LE InstallerDesman Com des fonction la et mentceplalemPalette LA DE Tracteur LE Retirer DE Avant DU Tracteur LE Sortir PourToncar Pente-Guide Montées NON PiécesClient DU Responsabilités SommaireProduit DE Spécifications CCA .MIN AMP/HRRemorquage EntretienEnfants Général EntretienPEN LES Dans Fonctionnement TESGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsCom.poulan.www web site notre Visitez PBA195H42LTX ModèleAUX Imprimé

418791, 96012008500 specifications

The Poulan 96012008500, 418791 is a high-quality string trimmer designed to cater to the needs of both homeowners and professional landscapers. This versatile tool is constructed with a focus on power, efficiency, and user comfort, making it an ideal choice for maintaining lawns, gardens, and other outdoor spaces.

One of the standout features of the Poulan 96012008500 is its robust 25cc, 2-cycle engine. This powerful engine offers excellent cutting performance while maintaining a lightweight design, allowing for easy maneuverability during use. It is engineered to provide optimal performance, enabling users to tackle tough jobs with ease. The engine's construction also emphasizes fuel efficiency, which promotes longer run times and reduces the frequency of refueling.

In addition to its impressive engine, the trimmer incorporates a dual-line cutting system with a bump-feed head. This feature allows for quick and easy line advancement with a simple tap on the ground, ensuring uninterrupted operation as users trim around obstacles and edges. The dual-line setup offers a wider cutting path, enhancing efficiency and reducing the time needed to complete lawn maintenance tasks.

Ergonomics play a crucial role in the design of the Poulan 96012008500. Equipped with an adjustable handle, users can easily customize the trimmer to their height for maximum comfort. The cushioned grip further minimizes fatigue during prolonged use, making it suitable for extended trimming sessions. The lightweight design of the trimmer also contributes to ease of use, reducing strain on the arms and back.

Another noteworthy technology implemented in this trimmer is the "Easy Start" feature, which simplifies the starting process. With this technology, users can quickly start the machine with minimal effort, allowing for a stress-free experience, especially for those who may have difficulty with traditional starting mechanisms.

Durability is also a key component of the Poulan 96012008500. It is crafted from high-quality materials resistant to wear and tear, ensuring that the trimmer can withstand the rigors of regular use. This reliability makes it a sound investment for anyone looking to maintain their yard or garden effectively.

Overall, the Poulan 96012008500, 418791 combines powerful performance, user-friendly features, and ergonomic design. Whether you are a homeowner aiming to keep your lawn neat or a professional landscaper needing a reliable tool, this string trimmer offers the performance and durability necessary for optimal efficiency in outdoor maintenance tasks.