Poulan 96012008500, 418791 manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thor- oughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PB195H42LTX ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Unassembled Parts Steering WheelSeat Keys Slope SheetAssembly Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Fig Check Battery See FigCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Reverse Operation System ROS See FigTo Operate on Hills Before Starting the Engine To Transport See FigsCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionAutomatic Transmission Warm UP RunningMaintenance Lubrication ChartTractor Blade Removal See FigTo Sharpen Blade See Fig Check Operator Presence SystemLubrication Battery EngineTransaxle Pump Fluid BeltsCleaning Clean AIR ScreenAIR Filter MufflerService and Adjustments To Install Mower See FigTo Level Mower Housing To Remove Mower See FigBelt Installation To Replace Mower Blade Drive Belt See FigBelt Removal To Check and Adjust Brake See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Brake To Replace Motion Drive Belt See FigTransmission REMOVAL/REPLACEMENT To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Outdoor Products Customer Service Dept HOPCanada contact Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAService Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Suivant LES UNE Pliez EST CeciDentretien Notes Dept Service Customer Products Outdoor Canada Au AutoriséGarantie cette de exclus sont normal l’entretien et Dépannage DE Guide Conducteur le lorsqueLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur Reglages ET Revision MoteurLA DE ENLEVEMENT/REMPLACEMENT RossageAVANT/CAR Roues DES Convergence LA DE L’ALIGNEMENT Régler PourFig la Voir ’EN Courroie LA Remplacer PourFrein LE Régler ET Contrôler Pour Transmission DE MentnetraîCourroie Acer Rempl Pour Tondeuse DE Lame DE MENTNETRAÎD’ENTondeuse DE Boîtier LE Niveler Pour 15 .FIGEntretien ’ALLUMAGE BougieAIR À Filtre ’AIR Tamis LE NettoyerSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementFig la Voir Lame LA Affiler Trapézoïdales CourroiesFig la Voir Lame LA Enlever EN Fonctionnement DE Système ETRecommandations LES GénéralesLubrification DE Tableau Utilisation Chaque AvantUtilisation Tondre DE ConseilsTransmission LA Purger QuetiMoteur LE Démarrer DE Avant Et 4 .Fig les Voir Tracteur LE Transporter PourPentes LES Dans Utiliser Pour Tondeuse LA Utiliser PourGAZ DES Commande LA Utiliser Pour Teurtrac Votre Utiliser CommentFig la Voir Arrêter Pour Fig la Voir Mentnetionsta DE Frein LE Engager PourLSW02838 ’EMBRAYAGE Montage NI DE EST Tondeuse LA SI VérifierDesmancom des tionfonc la et Tionsec la Voir Conduisant LE EN TeletFig la Voir Siège LE Installer Votre Monter CommentDesman Com des fonction la et mentceplalemDU Tracteur LE Sortir Pour Palette LA DE Tracteur LE Retirer DE AvantToncar Montées NON Piéces Pente-GuideSommaire Client DU ResponsabilitésProduit DE Spécifications CCA .MIN AMP/HREntretien RemorquageEnfants Général EntretienTES PEN LES Dans FonctionnementGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsPBA195H42LTX Modèle Com.poulan.www web site notre VisitezAUX Imprimé

418791, 96012008500 specifications

The Poulan 96012008500, 418791 is a high-quality string trimmer designed to cater to the needs of both homeowners and professional landscapers. This versatile tool is constructed with a focus on power, efficiency, and user comfort, making it an ideal choice for maintaining lawns, gardens, and other outdoor spaces.

One of the standout features of the Poulan 96012008500 is its robust 25cc, 2-cycle engine. This powerful engine offers excellent cutting performance while maintaining a lightweight design, allowing for easy maneuverability during use. It is engineered to provide optimal performance, enabling users to tackle tough jobs with ease. The engine's construction also emphasizes fuel efficiency, which promotes longer run times and reduces the frequency of refueling.

In addition to its impressive engine, the trimmer incorporates a dual-line cutting system with a bump-feed head. This feature allows for quick and easy line advancement with a simple tap on the ground, ensuring uninterrupted operation as users trim around obstacles and edges. The dual-line setup offers a wider cutting path, enhancing efficiency and reducing the time needed to complete lawn maintenance tasks.

Ergonomics play a crucial role in the design of the Poulan 96012008500. Equipped with an adjustable handle, users can easily customize the trimmer to their height for maximum comfort. The cushioned grip further minimizes fatigue during prolonged use, making it suitable for extended trimming sessions. The lightweight design of the trimmer also contributes to ease of use, reducing strain on the arms and back.

Another noteworthy technology implemented in this trimmer is the "Easy Start" feature, which simplifies the starting process. With this technology, users can quickly start the machine with minimal effort, allowing for a stress-free experience, especially for those who may have difficulty with traditional starting mechanisms.

Durability is also a key component of the Poulan 96012008500. It is crafted from high-quality materials resistant to wear and tear, ensuring that the trimmer can withstand the rigors of regular use. This reliability makes it a sound investment for anyone looking to maintain their yard or garden effectively.

Overall, the Poulan 96012008500, 418791 combines powerful performance, user-friendly features, and ergonomic design. Whether you are a homeowner aiming to keep your lawn neat or a professional landscaper needing a reliable tool, this string trimmer offers the performance and durability necessary for optimal efficiency in outdoor maintenance tasks.
Top Page Image Contents