Poulan 418791 manual Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 19

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place motion control lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 15)

Mower will be easier to remove from the right side of tractor.

•Place attachment clutch in “DISENGAGED” position.

•Move attachment lift lever forward to lower mower to its lowest position.

•Roll belt off engine pulley.

•Remove small retainer spring, and remove clutch spring off pulley bolt.

•Remove large retainer spring, slide collar off and push housing guide out of bracket.

•Disconnect anti-swaybar from chassis bracket by re- moving retainer spring.

•Disconnect suspension arms from rear deck brackets by removing retainer springs.

•Disconnect front links from deck by removing retainer springs.

•Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS AND HOOK THE CLUTCH SPRING INTO SQUARE HOLE IN FRAME.

TO INSTALL MOWER (See Fig. 15)

•Raise attachment lift lever to its highest position.

•Slide mower under tractor with deflector shield to right side of tractor.

•Lower lift lever to its lowest position.

•Connect front links to mower deck and secure with retainer springs..

•Connect suspension arms to rear deck brackets and secure with retainer springs.

•Connect anti-swaybar to chassis bracket and secure with retainer spring.

•Push clutch cable housing guide into bracket, slide col- lar onto guide and secure with large retainer spring.

•Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.

•Install belt onto engine pulley.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

 

SMALL RETAINER SPRING

 

 

 

 

CLUTCH SPRING

 

 

 

 

FLAT WASHER

 

 

SQUARE HOLE

SMALL RETAINER SPRING

 

SUSPENSION

ENGINE PULLEY

 

 

 

ARMS

 

 

 

 

CLUTCH SPRING

 

 

 

 

 

 

 

FRONT LINK

RETAINER SPRING

 

 

 

 

ANTI-SWAY BAR

 

 

 

 

 

 

 

 

RETAINER SPRINGS

COLLAR

 

 

 

(BOTH SIDES)

HOUSING GUIDE

LARGE RETAINER

 

 

 

SPRING

BRACKET

 

DEFLECTOR SHIELD

 

 

 

 

 

 

 

FIG. 15

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Model PB195H42LTXII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIII. Children ServiceIV. Towing Table of Contents Keys Slope Sheet Unassembled PartsSteering Wheel SeatBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Install Seat See FigCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS See Fig To Operate Mower See FigTo Operate on Hills ADD Gasoline Before Starting the EngineTo Transport See Figs Check Engine OIL LevelRunning Mowing TipsPurge Transmission Automatic Transmission Warm UPLubrication Chart MaintenanceCheck Operator Presence System TractorBlade Removal See Fig To Sharpen Blade See FigBelts Lubrication BatteryEngine Transaxle Pump FluidMuffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal To Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Adjust BrakeFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Stevens Creek Road Terry Fox Way Augusta, GA 30907 USA Outdoor Products Customer Service DeptHOP Canada contactService Notes Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LESDentretien Notes Autorisé Dept Service Customer Products Outdoor Canada AuGarantie cette de exclus sont normal l’entretien et Conducteur le lorsque Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Moteur EntreposageTracteur Moteur Reglages ET RevisionLA DE L’ALIGNEMENT Régler Pour LA DE ENLEVEMENT/REMPLACEMENTRossage AVANT/CAR Roues DES ConvergenceTransmission DE Mentnetraî Fig la Voir’EN Courroie LA Remplacer Pour Frein LE Régler ET Contrôler PourTondeuse DE Lame DE MENTNETRAÎD’EN Courroie Acer Rempl Pour15 .FIG Tondeuse DE Boîtier LE Niveler Pour’AIR Tamis LE Nettoyer Entretien’ALLUMAGE Bougie AIR À FiltreTrapézoïdales Courroies Sionmistrans LA DE Moteur FluideTransmission LA DE Refroidissement Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Recommandations LESGénérales Lubrification DE TableauQueti UtilisationTondre DE Conseils Transmission LA PurgerMoteur LE Démarrer DE Avant Tondeuse LA Utiliser Pour Et 4 .Fig les VoirTracteur LE Transporter Pour Pentes LES Dans Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourTeurtrac Votre Utiliser Comment Fig la Voir Arrêter PourLSW02838 ’EMBRAYAGE Tionsec la Voir Conduisant LE EN Telet MontageNI DE EST Tondeuse LA SI Vérifier Desmancom des tionfonc la etCom des fonction la et mentceplalem Fig la Voir Siège LE InstallerVotre Monter Comment DesmanPalette LA DE Tracteur LE Retirer DE Avant DU Tracteur LE Sortir PourToncar Pente-Guide Montées NON PiécesCCA .MIN AMP/HR SommaireClient DU Responsabilités Produit DE SpécificationsGénéral Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils TESPEN LES Dans Fonctionnement Général FonctionnementCom.poulan.www web site notre Visitez PBA195H42LTX ModèleAUX Imprimé

418791, 96012008500 specifications

The Poulan 96012008500, 418791 is a high-quality string trimmer designed to cater to the needs of both homeowners and professional landscapers. This versatile tool is constructed with a focus on power, efficiency, and user comfort, making it an ideal choice for maintaining lawns, gardens, and other outdoor spaces.

One of the standout features of the Poulan 96012008500 is its robust 25cc, 2-cycle engine. This powerful engine offers excellent cutting performance while maintaining a lightweight design, allowing for easy maneuverability during use. It is engineered to provide optimal performance, enabling users to tackle tough jobs with ease. The engine's construction also emphasizes fuel efficiency, which promotes longer run times and reduces the frequency of refueling.

In addition to its impressive engine, the trimmer incorporates a dual-line cutting system with a bump-feed head. This feature allows for quick and easy line advancement with a simple tap on the ground, ensuring uninterrupted operation as users trim around obstacles and edges. The dual-line setup offers a wider cutting path, enhancing efficiency and reducing the time needed to complete lawn maintenance tasks.

Ergonomics play a crucial role in the design of the Poulan 96012008500. Equipped with an adjustable handle, users can easily customize the trimmer to their height for maximum comfort. The cushioned grip further minimizes fatigue during prolonged use, making it suitable for extended trimming sessions. The lightweight design of the trimmer also contributes to ease of use, reducing strain on the arms and back.

Another noteworthy technology implemented in this trimmer is the "Easy Start" feature, which simplifies the starting process. With this technology, users can quickly start the machine with minimal effort, allowing for a stress-free experience, especially for those who may have difficulty with traditional starting mechanisms.

Durability is also a key component of the Poulan 96012008500. It is crafted from high-quality materials resistant to wear and tear, ensuring that the trimmer can withstand the rigors of regular use. This reliability makes it a sound investment for anyone looking to maintain their yard or garden effectively.

Overall, the Poulan 96012008500, 418791 combines powerful performance, user-friendly features, and ergonomic design. Whether you are a homeowner aiming to keep your lawn neat or a professional landscaper needing a reliable tool, this string trimmer offers the performance and durability necessary for optimal efficiency in outdoor maintenance tasks.
Top Page Image Contents