Poulan 417217 manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean en- gine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PB195H46YT ModelSafety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor DHEHOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Operate MowerBefore Starting the Engine Reverse Operation System ROSTo Operate on Hills To Transport See FigsADD Gasoline To Start Engine See FigPurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsService and Adjustments To Install Mower See -21To Remove Mower See Fig Service and Adjustments To Level Mower Turn nut right Turn nut left To raise mower To lower mowerTo Replace Mower Drive Belt See Fig To Check BrakeTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See Fig Replacing Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Suggested Guide for Sighting Slopes for Safe Operation Limited Warranty L5V 3E4Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Remarques Autorisé Garantie cette de exclus sont normal l’entretien etInitiale d’achat date la de compter à jours 90 dix Degrés Suivant LES UNE Pliez EST CeciDépannage DE Guide Correction Cause ProblèmeLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur Starter DU Commande LA Régler Pour GAZ DES Commande LA DE Câble LE Régler PourReglages ET Revision MoteurFig la Voir Batterie LA Replacer Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Roue LA DE PINCEMENT/CARROSSAGE Réglages ET Révision Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourFreins LES Vérifier Pour 27 .FIGTondeuse LA Niveau LE Ajuster Pour 25 .FIG24 .FIG 23 .FIG21 .FIG 19 .FIG 20 .FIG18 .FIG Coin le Soulevez C Arrières Bielles LES AttachezCourroie LA ET Tondeuse LA Installer Fig VoirTondeuse LA Enlever Pour 17 .FIGEntretien Fig la Voir’ALLUMAGE Bougie Moteur DE D’HUILE FiltreAIR À Filtre ’AIR Tamis LE NettoyerSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementFig la Voir Lame LA Enlever EN Fonctionnement DE Système ETRecommandations LES GénéralesLubrification DE Tableau Utilisation Chaque AvantUtilisation Tondre DE Conseils12 .FIG Transmission LA Purger Moteur LE Démarrer PourQuetimaauto Sion Transmis DE RéchauffementMoteur LE Démarrer DE Avant 11 et 3 .Fig les VoirMAR EN Fonctionnement DE Système Tondeuse LA Utiliser Pour Jauge DE Roues LES Régler Pour10 .FIG Système DU CaractéristiquesGAZ DES Commande LA Utiliser Pour VitessDE Régulateur LE Utiliser Comment Fig la Voir Mentnetionsta DE Frein LE Engager PourUtilisation ’EMBRAYAGE Montage Desmancom des tionfonc la etLA DE Tracteur LE Retirer Pour Montées NON Piéces Toncar DU Tracteur LE Sortir PourFig la Voir Batterie LA Vérifier Fig la Voir Siège LE AjustezSommaire Client DU ResponsabilitésProduit DE Spécifications Entretien RemorquageEnfants Général EntretienPentes LES Dans FonctionnementGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé Avertissement

417217 specifications

The Poulan 417217 is a robust and versatile chainsaw that caters to both professional and amateur users alike. Known for its reliability and ease of use, the Poulan 417217 has gained a reputation in the market as an efficient tool for various cutting tasks, from trimming trees to felling larger timber.

At the heart of the Poulan 417217 is its powerful engine, typically featuring a 42cc two-stroke engine that provides a balance between power and efficiency. This engine delivers a sufficient horsepower output to tackle demanding jobs while maintaining manageable weight for user comfort. The advanced engine design also ensures reduced emissions, making it an environmentally-friendly option for users concerned about their carbon footprint.

One of the standout features of the Poulan 417217 is its ease of starting. The chainsaw is equipped with an automatic oiler system that keeps the chain lubricated during use, prolonging its lifespan and maintaining optimal performance. The quick-release air filter system allows for simple maintenance and easy access when cleaning, which is crucial for the longevity and reliability of the tool.

The chainsaw's 18-inch cutting bar is designed for efficient cutting and maneuverability. It makes quick work of branches and logs, providing smooth performance on various materials. Coupled with a low-kickback chain, safety becomes a priority, helping to prevent accidents during operation.

Ergonomically designed handles enhance user comfort and control, minimizing fatigue during extended periods of use. The vibration dampening technology integrated into the handle design further contributes to an enjoyable user experience by reducing vibrations that can lead to hand fatigue.

The Poulan 417217 also features a combination of a primer bulb and a choke for quick and easy starting, allowing the user to begin their task with minimal delay. Additionally, the chainsaw's lightweight design allows for easy transport and prolonged use without excessive strain.

In summary, the Poulan 417217 offers a combination of power, safety, and user-friendly features, making it an ideal choice for anyone seeking a dependable chainsaw. Whether you are a seasoned professional or a novice, the 417217 equips you with the performance needed to achieve your cutting goals efficiently and safely.
Top Page Image Contents