Poulan 417217 manual Unassembled Parts, Assembly, To Remove Tractor from Carton, Unpack Carton

Page 5

UNASSEMBLED PARTS

Slope Sheet

Key

(1) Oil Drain Tube

(2) Keys

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping puposes.

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton.

•Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.

•Check for any additional loose parts or cartons and remove.

CHECK BATTERY (See Fig. 1)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in the Maintenance section of this manual for charging instructions).

DISCARD TERMINAL

KEPS NUT

HEX BOLT

 

PROTECTIVE CAPS

 

 

 

TERMINAL

COVER

NEGATIVE (BLACK) CABLE

POSITIVE (RED) CABLE

ADJUST SEAT (See Fig. 2)

•Sit in seat.

•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

•Release lever to lock seat in position.

A

FIG. 2

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

03037

FIG. 1

5

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

1. Raise attachment lift lever to its highest position.

2. Release parking brake by depressing brake pedal.

3. Place freewheel control in disengaged position to dis- engage transmission (See “TO TRANSPORT” in the Operation section of this manual).

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Model PB195H46YTSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Unassembled Parts AssemblyTo Remove Tractor from Carton Unpack CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation DHE Know Your TractorStopping HOW to USE Your TractorTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigSystem Characteristics To Operate MowerReverse Operation System ROS Before Starting the EngineTo Operate on Hills To Transport See FigsTo Start Engine See Fig ADD GasolinePurge Transmission Automatic Transmission Warm UPMowing Tips Maintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBrake Operation TiresEngine Engine OIL Filter CleaningMuffler Spark PlugsTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See -21 Service and Adjustments Turn nut right Turn nut left To raise mower To lower mower To Level MowerTo Replace Motion Drive Belt See Fig To Replace Mower Drive Belt See FigTo Check Brake Replacing Battery See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Suggested Guide for Sighting Slopes for Safe Operation L5V 3E4 Limited WarrantyService Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Remarques Initiale d’achat date la de compter à jours 90 dix AutoriséGarantie cette de exclus sont normal l’entretien et UNE Pliez EST Ceci Degrés Suivant LESCorrection Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Tracteur EntreposageMoteur GAZ DES Commande LA DE Câble LE Régler Pour Starter DU Commande LA Régler PourReglages ET Revision MoteurAvant Roue LA DE PINCEMENT/CARROSSAGE Fig la Voir Batterie LA ReplacerFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Réglages ET RévisionFreins LES Vérifier Pour 27 .FIG25 .FIG Tondeuse LA Niveau LE Ajuster Pour24 .FIG 23 .FIG20 .FIG 21 .FIG 19 .FIG18 .FIG Coin le Soulevez C Arrières Bielles LES AttachezFig Voir Courroie LA ET Tondeuse LA InstallerTondeuse LA Enlever Pour 17 .FIGFig la Voir Entretien’ALLUMAGE Bougie Moteur DE D’HUILE Filtre’AIR Tamis LE Nettoyer AIR À FiltreSionmistrans LA DE Moteur Fluide Transmission LA DE RefroidissementEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverGénérales Recommandations LESLubrification DE Tableau Utilisation Chaque Avant12 .FIG UtilisationTondre DE Conseils Moteur LE Démarrer Pour Transmission LA PurgerQuetimaauto Sion Transmis DE RéchauffementMAR EN Fonctionnement DE Système Moteur LE Démarrer DE Avant11 et 3 .Fig les Voir Jauge DE Roues LES Régler Pour Tondeuse LA Utiliser Pour10 .FIG Système DU CaractéristiquesVitess GAZ DES Commande LA Utiliser PourDE Régulateur LE Utiliser Comment Fig la Voir Mentnetionsta DE Frein LE Engager PourUtilisation ’EMBRAYAGE LA DE Tracteur LE Retirer Pour MontageDesmancom des tionfonc la et Toncar DU Tracteur LE Sortir Pour Montées NON PiécesFig la Voir Batterie LA Vérifier Fig la Voir Siège LE AjustezProduit DE Spécifications SommaireClient DU Responsabilités Remorquage EntretienEnfants Général EntretienLES Dans Fonctionnement PentesGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAvertissement AUX Imprimé

417217 specifications

The Poulan 417217 is a robust and versatile chainsaw that caters to both professional and amateur users alike. Known for its reliability and ease of use, the Poulan 417217 has gained a reputation in the market as an efficient tool for various cutting tasks, from trimming trees to felling larger timber.

At the heart of the Poulan 417217 is its powerful engine, typically featuring a 42cc two-stroke engine that provides a balance between power and efficiency. This engine delivers a sufficient horsepower output to tackle demanding jobs while maintaining manageable weight for user comfort. The advanced engine design also ensures reduced emissions, making it an environmentally-friendly option for users concerned about their carbon footprint.

One of the standout features of the Poulan 417217 is its ease of starting. The chainsaw is equipped with an automatic oiler system that keeps the chain lubricated during use, prolonging its lifespan and maintaining optimal performance. The quick-release air filter system allows for simple maintenance and easy access when cleaning, which is crucial for the longevity and reliability of the tool.

The chainsaw's 18-inch cutting bar is designed for efficient cutting and maneuverability. It makes quick work of branches and logs, providing smooth performance on various materials. Coupled with a low-kickback chain, safety becomes a priority, helping to prevent accidents during operation.

Ergonomically designed handles enhance user comfort and control, minimizing fatigue during extended periods of use. The vibration dampening technology integrated into the handle design further contributes to an enjoyable user experience by reducing vibrations that can lead to hand fatigue.

The Poulan 417217 also features a combination of a primer bulb and a choke for quick and easy starting, allowing the user to begin their task with minimal delay. Additionally, the chainsaw's lightweight design allows for easy transport and prolonged use without excessive strain.

In summary, the Poulan 417217 offers a combination of power, safety, and user-friendly features, making it an ideal choice for anyone seeking a dependable chainsaw. Whether you are a seasoned professional or a novice, the 417217 equips you with the performance needed to achieve your cutting goals efficiently and safely.
Top Page Image Contents