Rhino Mounts FM100 Lubrication Information, Lubrication Fitting Location, Description Frequency

Page 84

MAINTENANCE

MAINTENANCE

Before operating your Finishing Mower, make sure it is properly lubricated and thoroughly inspected. Only a minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and trouble free operation.

WARNING! Always disengage the PTO before raising the Rotary Cutter for transporting or making adjustments.

LUBRICATION INFORMATION

Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The illustrations below shows lubrication points. The chart gives the frequency of lubrication in hours, based on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. Figure 1.

Use an SAE multi-purpose, lithium-type grease for all locations shown. Be sure to clean the fitting thoroughly before using grease gun. Failure to maintain proper lubrication will result in damage to U-joints, gearbox, and/ or driveshaft.

1

2	3
2
5	1
5
	4

1

3

3

2

2

5

	1
	2
	LUBRICATION FITTING LOCATION FIGURE1
ITEM	DESCRIPTION	FREQUENCY
1	Gauge Wheel Pivots	apply light oil weekly
2	Wheel Hubs	8 Hours or daily
3	Blade Spindle	8 Hours or daily
4	U-Joint Telescoping Member	8 Hours or daily
5	U-Joints	8 Hours or daily
FM100 02/04	Maintenance Section 5-2
© 2004 Alamo Group Inc.

Image 84

Contents FM100 To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Peligro ¡LEA ELInstructivo Safety Safety Following rules Keep Away from Rotating Elements to prevent entanglement Safety Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO DealerSafety Decal Location QTY Level DescriptionSafety Decals D103 Safety Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Exceed Horsepower Recommendations Dealer SET-UP Instructions Frame AttachmentLower Hitch Attachment Caster Wheel AttachmentsPage Operation Section Tractor Preparation Attaching Mower to Tractor Lift TypeCutting Height Adjustment Driveline Attachment to TractorStarting & Stopping Cutter Cutting Speed Cutting TipsDetaching and Storing Driveline Length Check Procedure Before Operating or Transporting this MowerDriveline Length Front Gauge Wheel Interference CheckProblem Possible Cause Remedy StreakingDamaged Belt Maintenance Section Lubrication Information Lubrication Fitting LocationDescription Frequency Gearbox Gauge Wheel AssembliesDriveline Lubrication Blade Spindle LubricationBlade Installation Blade ServicingBlade Sharpening Blade RemovalBelt Adjustment Procedure Figure Storage Proper Torque for FastenersMaintenance SERVIS-RHINO Page Gearbox Warranty To the OWNER/OPERATOR/DEALERFM100-SOM-02/04 00767123C Printed U.S.A RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy