Rhino Mounts FM100 manual Belt Adjustment Procedure Figure

Page 88

MAINTENANCE

MAINTENANCE

BELT ADJUSTMENT PROCEDURE Figure 7.

Shut off mower and tractor. . Loosen jam nut (item 1) on tension adjustment bolt (item 2). Tighten adjustment bolt (item 3) until belt deflection along front of belt (item 4) is 3/4" with approximately 10 pounds applied to center of length. DO NOT OVERTIGHTEN. Tighten jam nut (item 1).

BELT REMOVAL/INSTALLATION Figure 7.

Gearbox Mount Plate

5

2 1

3

4

Deflection is 3/4" when

applying 10 Lbs of

preasure

FIGURE 7

Shut off mower and tractor. Remove belt shield fasteners and belt shields. Loosen tension on belts as described above. Slip old belts under gearbox mount plate and under center spindle sheave (item 5). Slip new belts under gearbox mount plate and under center spindle sheave ). Feed belts as shown in Figure 7 and tighten belts as described in the Belt Adjustment Procedure. Reinstall shields and shield fasteners.

FM100 02/04	Maintenance Section 5-6
© 2004 Alamo Group Inc.

Image 88

Contents FM100 To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section ¡LEA EL PeligroInstructivo Safety Safety Following rules Keep Away from Rotating Elements to prevent entanglement Safety Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO DealerSafety Decal Location QTY Level DescriptionSafety Decals D103 Safety Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Exceed Horsepower Recommendations Dealer SET-UP Instructions Frame AttachmentLower Hitch Attachment Caster Wheel AttachmentsPage Operation Section Tractor Preparation Attaching Mower to Tractor Lift TypeDriveline Attachment to Tractor Cutting Height AdjustmentStarting & Stopping Cutter Cutting Tips Cutting SpeedDetaching and Storing Driveline Length Check Procedure Before Operating or Transporting this MowerDriveline Length Front Gauge Wheel Interference CheckProblem Possible Cause Remedy StreakingDamaged Belt Maintenance Section Lubrication Fitting Location Lubrication InformationDescription Frequency Gearbox Gauge Wheel AssembliesDriveline Lubrication Blade Spindle LubricationBlade Installation Blade ServicingBlade Sharpening Blade RemovalBelt Adjustment Procedure Figure Storage Proper Torque for FastenersMaintenance SERVIS-RHINO Page Gearbox Warranty To the OWNER/OPERATOR/DEALERFM100-SOM-02/04 00767123C Printed U.S.A RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy