Rhino Mounts FM100 manual Wait a minute...Save a life

Page 15
(SFM-2)
(SPT-1)

SAFETY

WARNING! Never leave Tractor and Implemented unattended while the implement is in the lifted position. Accidental operation of lifting lever or a hydraulic failure may cause sudden drop of unit with injury or death by crushing. To properly park the implement when disconnecting it from the tractor, lower the stand and put the retaining pin securely in place, or put a secure support under the A-Frame. Lower the implement carefully to the ground. Do not put hands or feet under lifted components.

SAFETY

DANGER!

WARNING!

Make sure the PTO shield, integral driveline shields, and input shields are is installed when using PTO-driven equipment. Always replace any shield if it is damaged or missing. (S3PT-8)

Relieve hydraulic pressure prior to doing any maintenance or repair work on the Implement. Place the Implement on the ground or securely blocked up, disengage the PTO, and turn off the tractor engine. Push and pull the Remote Cylinder lever in and out several times prior to starting any maintenance or repair work. (S3PT-9)

WARNING!

The rotating parts of this machine continue to rotate even after the PTO

 

has been turned off. The operator should remain in his seat for 60

 

seconds after the brake has been set, the PTO disengaged, the tractor

 

turned off, and all evidence of rotation has ceased.

(3PT-10)

 

“Wait a minute...Save a life!”

DANGER!

This Implement is wider than the Tractor. Be careful when operating

 

or transporting this equipment to prevent the Implement from running

 

into or striking sign posts, guard rails, concrete abutments or other

 

solid objects. Such an impact could cause the Implement and Tractor

 

to pivot violently resulting in loss of steering control, serious injury, or

 

even death. Never allow the Implement to contact obstacles. (S3PT-12)

DANGER!

There are obvious and hidden potential hazards in the operation of this

 

Mower. REMEMBER! This machine is often operated in weeds and

 

in heavy grass. The Blades of this Mower can throw objects if shields

 

are not properly installed and maintained. Serious injury or even death

 

may occur unless care is taken to insure the safety of the operator,

 

bystanders, or passersby in the area. Do not operate this machine

 

with anyone in the immediate area. Stop mowing if anyone is within

 

100 yards of mower. (SFM-1)

DANGER! All Safety Shields, Guards and Safety devices including (but not limited to) - the Discharge Deflectors, Steel Guards, Gearbox Shields, Belt Shileds, and PTO Shields should be used and maintained in good working condi- tion. All safety devices should be inspected carefully at least daily for missing or broken components. Missing, broken, or worn items must be replaced at once to reduce the possibility of injury or death from thrown objects, entanglement, or blade contact.

FM100 02/04

Safety Section 1-9

© 2004 Alamo Group Inc.

 

Image 15
Contents FM100 To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Peligro ¡LEA ELInstructivo Safety Safety Following rules Keep Away from Rotating Elements to prevent entanglement Safety Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life See Your SERVIS-RHINO Dealer Parts InformationQTY Level Description Safety Decal LocationSafety Decals D103 Safety Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Frame Attachment Exceed Horsepower Recommendations Dealer SET-UP InstructionsCaster Wheel Attachments Lower Hitch AttachmentPage Operation Section Attaching Mower to Tractor Lift Type Tractor PreparationCutting Height Adjustment Driveline Attachment to TractorStarting & Stopping Cutter Cutting Speed Cutting TipsDetaching and Storing Before Operating or Transporting this Mower Driveline Length Check ProcedureFront Gauge Wheel Interference Check Driveline LengthStreaking Problem Possible Cause RemedyDamaged Belt Maintenance Section Lubrication Information Lubrication Fitting LocationDescription Frequency Gauge Wheel Assemblies GearboxBlade Spindle Lubrication Driveline LubricationBlade Removal Blade InstallationBlade Servicing Blade SharpeningBelt Adjustment Procedure Figure Proper Torque for Fasteners StorageMaintenance SERVIS-RHINO Page To the OWNER/OPERATOR/DEALER Gearbox WarrantyFM100-SOM-02/04 00767123C Printed U.S.A RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy