Scag Power Equipment STC52V-27CV-SS manual Safety Information, Signal Words

Page 7

Section 2

R

SAFETY INFORMATION

2.1 Introduction

Your mower is only as safe as the operator. Carelessness or operator error may result in serious bodily injury or death. Hazard control and accident prevention are dependent upon the awareness, concern, prudence, and proper training of the personnel involved in the operation, transport, maintenance and storage of the equipment. Make sure every operator is properly trained and thoroughly familiar with all of the controls before operating the mower. The owner/user can prevent and is responsible for accidents or injuries occurring to themselves, other people or property.

READ THIS OPERATOR’S MANUAL BEFORE ATTEMPTING TO START YOUR MOWER.

A replacement manual is available from your authorized Scag Service Dealer or by contacting Scag Power Equipment, Service Department at P.O. Box 152, Mayville, WI 53050 or contact us via the Internet at www.scag.com. The manual for this machine can be downloaded by using the model and serial number or use the contact form to make your request. Please indicate the complete model and serial number of your Scag product when requesting replacement manuals.

2.2 Signal Words

Danger

The signal word “DANGER” denotes that an extremely hazardous situation exists on or near the machine that could result in high probability of death or irreparable injury if proper precautions are not taken.

Warning

The signal word “WARNING” denotes that a hazard exists on or near the machine that can result in injury or death if proper precautions are not taken.

Caution

The signal word “CAUTION” is a reminder of safety practices on or near the machine that could result in personal injury if proper precautions are not taken.

Your safety and the safety of others depends significantly upon your knowledge and understanding of all correct operating practices and procedures of this machine.

This symbol means “Attention! Become Alert! Your

Safety is Involved!" The symbol is used with the following signal words to attract your attention to safety messages found on the decals on the machine and throughout this manual. The message that follows the symbol contains important information about safety. To avoid injury and possible death, carefully read the message! Be sure to fully understand the causes of possible injury or death.

Signal Word:

It is a distinctive word found on the safety decals on the machine and throughout this manual that alerts the viewer to the existence and relative degree of the hazard.

2.3Before Operation considerations

1.NEVER allow children to operate this riding mower. Do not allow adults to operate this machine without proper instructions.

2.Do not mow when children and/or others are present. Keep children out of the mowing area and in the watchful care of a responsible adult other than the operator. Be alert and turn machine off if a child enters the area.

3.DO NOT allow children to ride or play on the machine, it is not a toy.

4.Clear the area to be mowed of objects that could be picked up and thrown by the cutter blades.

5.DO NOT carry passengers.

6.DO NOT operate the machine under the influence of alcohol or drugs.

3

Image 7
Contents OPERATOR’S Manual STC48V-19KAI Remember Your Mower is only AS Safe AS the OperatorSTC52V-27CV-SS Table of Contents Following Section Limited Warranty Commercial EquipmentDirection Reference USE only Scag Approved Attachments and AccessoriesGeneral Information IntroductionSymbol Description SymbolsSTT Models Signal Word Safety InformationSignal Words This symbol means Attention! Become Alert! YourOperation Considerations Section Foldable Roll-Over Protection System Roll-over protection systemSeat Belt Inspection Using a spark arrestor Maintenance Considerations & storageInstall Belt COvER Before Safety and Instructional DecalsElectrical EngineTractor Productivity Weights and Dimensions 48V 52V 61VCutter Deck Hydraulic SystemControls and Instrument Identification Operating InstructionsInitial RUN-IN Procedures Safety Interlock SystemFirst Day of Use or Approximately 20 Hours Ground Travel and Steering Starting the EngineForward Travel Reverse Travel Engaging the Deck Drive Cutter BladesAfter Operation Rotating BladesHillside Operation Parking the MowerMoving Mower with Engine Stopped Adjusting Cutting HeightRecommendations for Mowing Deck Release Lever Towing optional hitch accessoryCondition Cause Cure Troubleshooting Cutting ConditionsTroubleshooting Cutting Conditions Contd Cutting path Scalping Blades HittingDirt or CuttingVery Close To the Ground Step Cut Ridge in CenterParking Brake Adjustment AdjustmentsTravel Adjustments Tracking Adjustment Neutral AdjustmentBelt Alignment Throttle Control and Choke AdjustmentsBelt Adjustment Cutter Deck AdjustmentsCutter Deck Pitch Cutter Deck Height Cutter Deck Height AdjustmentPosition Custom-Cut Baffle Adjustment Custom-Cut Baffle AdjustmentClutch Air Gap Adjustment Electric clutch adjustmentHours MaintenanceMaintenance Chart Recommended Service Intervals Procedure Comments Break-In 100 200 500 FirstLocation Lubrication Interval Lubricant NO. Places LubricationLubrication Fitting Points Changing Hydraulic Oil Checking Hydraulic Oil LevelEngine Fuel System Engine OilCleaning and/or Replacing Air Cleaner Element Engine Air CleanerReplacing In-Line Fuel Filter Elements Jump Starting BatteryCharging the Battery Battery Electrolyte First AIDBlade Inspection Blade ReplacementDrive Belts Cutter BladesBODY, DECK, and Upholstery TiresScag Approved Attachments and Accessories Illustrated Parts List48V & 52V Cutter Decks Description 61V Cutter Deck 424367 Dust Shield 483210 Idler Pulley, 5 Dia Cutter Deck Controls Cutter Deck Controls Sheet Metal Components 482619 Tire, 13 x 6.5-6 Smooth 483736 STC Foldable ROLL-OVER Protection System STC Foldable ROLL-OVER Protection System STC Suspension Seat Section Drive System Components 04019-04 Nut, Serr. Flange 3/8-16 04001-136 Engine & Attaching Parts Section Steering Components Damper orange colored print Damper blue colored print Brake Components Brake Components HYDRO-GEAR Parker Wheel Motor Part Number IdentificationSection 33 47 Fuel and Hydraulic System Electrical System Battery, 350CCA Not Available Through Scag BDP-10A Hydraulic Pump Assembly Housing Kit Manufactured Under ONE or More Replacement Decals and Information Plates482166R STC 2009 RDP2 PTO Switch Diode KEY Electrical SchematicLimited Warranty Commercial Equipment Garantía Limitada Equipo Comercial Está mientras equipo del parte ninguna lave No RecauciónPCorte de cuchillas con trabajar al ojos y CuchillaNota Cuchilla la de Reemplazo .8-7 Figura NotaAfilado.B Transmisión DE CorreasRranB Electrolito Para Auxilios Primeros 7aterBater Deaíla Bater DEMotor Aire del Iltro7 Motor Ceite7 MotorCombustiblede Istema5.7delHidráulico aceite de Depósito .2-7 Figura Hidrulicoá S istema3.7Aceite hidrulicoCáambio.B Aceite De nivel Hidrulicoá ErificarV.AConexión de puntos de Lubricación .1-7 Figura Horas Ubicaciones Lubricante Lubricación UbicaciónDE Intervalo Observaciones ProcedimientoObservaciones Procedimiento Primeros Inicial USO Horas Sección Corte de plataforma la de Tope .7-6 Figura Personalizado a 7juste.6ctorlCorte de plataforma la de altura de Ajuste .6-6 Figura Corte de plataforma la de nivel del Ajuste .5-6 FiguraAdvertencia Control de varilla la de Ajuste .3-6 Figura Dirección deAjustes Solución Causa Condición Coninuaciónt ID E Enganche cional Remolque14.4orio Descarga de válvula de Control .4-4 Figure Corte DE Altura LA DE AjustePeligro RecauciónP Precaución Descarga de válvula de Control .2-4 Figure Inicial Arranque DE ProcedimientosInterruptor El .1-4 Figura encendido de Interruptor Instrumentos e Controles .1-4 Figure61V 52V 48V PRO Especificaciones SE DE Yuridadas G Instructi CALCOMANÍAS.27 Ertenciaadv Almacenamiento mantenimiento ErtenciaadRops del Bisagra .2-2 Figura Seguridad de cinturón del Inspección .3-2 FiguraVuelco contra protección de Sistema .1-2 Figura Protecciónde UelcovPOR Aprobadas Operaciones LAS CON OshaDe freno el desconectada, esté plataforma de Defectuosamente Funcionando ni desconectado bloqueo deNo estacionamiento de freno el y neutral la de Diferente posición una en dirección de controlRidadg SE DEInformación Señalización DE PalabrasDescripción Símbolo STTScag POR Aprobados Dispositivos USE Sólo General InformaciónInstrucciones DE REFERENCIA12 INTRODUCCIÓN11Stali GarantManten Ridad Advertencia Operador DEL Manual