Quantum 9700 user manual Left Button, Output Sections

Page 10

Left Button

For numeric items, this button is used to select which digit in a numeric entry is selected for editing. For other items, or when the left most digit is already selected for numeric items, pressing and holding this button down displays a brief description of the current item.

Right Button

For numeric items, this button is used to select which digit in a numeric entry is selected for editing. For other items, or when the right most digit is already selected for numeric items, press and hold this button down to display the range and units for the current item.

Stop Button

Disables output of pulses on all channels.

Run Button

Enables output of pulses.

Output Sections

There are two (2) output sections on the front of the 9700; each consists of a pair of banana plugs, a BNC current monitor, a toggle switch, and a charge level indicator. Each output section is independently controlled and isolated from each other. Loads are connected to the banana plugs. The toggle switch allows the user to physically disconnect the output (off position). Disconnecting the outputs is recommended while connecting loads.

Warning: The charge bank voltage is present on the positive (red) output jack; before connecting loads, disconnect bank voltage by placing toggle switch in off position.

6

Image 10
Contents Series Pulse Generator Table of Contents Mode Pulse Modes External Trigger Mode Single Shot Mode Iii Introduction Parts ListWarranty Technical SupportSafety Issues Custom ModificationsPage Page Display Controls and ConnectorsFront Panel Control ButtonsLeft Button Output SectionsSync Out Rear PanelExternal Trigger InterlockGpib Port optional AC InputOperating Instructions OverviewMode Pulse Modes Numeric Input ModeItem Edit Mode Main MenuChannel Menus Enable TnEnableNDly Tn Delay NIamps TnIampsStore/Recall/Misc. Menus Store ConfigurationRecall Configuration NWid TnPulse WidthFmark VolumeShot Counter GPIBAddr optionalPage Command Language Serial RS232 PinoutCommand Protocol OkcrlfCommunication Protocol Command List Communication CommandsSpecifications DelaysOutputs Maintenance Replacing the FusePage Custom Features Long Pulse Option Specifications