Quantum 9700 user manual Maintenance, Replacing the Fuse

Page 25

5MAINTENANCE

Except for fuse replacement, the 9700 should require no maintenance.

A pair of fuses are mounted in the power entry module. To replace fuses, follow the instructions given below:

1.Unplug the 9700 from power source and remove power cord from the back panel.

2.Remove the fuse holder by pushing down on the center tab and pulling out.

3.Remove the faulty fuse and replace with one of a similar rating.

4.Reinstall the fuse holder.

5.Reattach the power cord.

Image 25

Contents Series Pulse Generator Table of Contents Mode Pulse Modes External Trigger Mode Single Shot Mode Iii Warranty Parts ListIntroduction Technical SupportCustom Modifications Safety IssuesPage Page Front Panel Controls and ConnectorsDisplay Control ButtonsOutput Sections Left ButtonExternal Trigger Rear PanelSync Out InterlockAC Input Gpib Port optionalOverview Operating InstructionsItem Edit Mode Numeric Input ModeMode Pulse Modes Main MenuNDly Tn Delay Enable TnEnableChannel Menus NIamps TnIampsRecall Configuration Store ConfigurationStore/Recall/Misc. Menus NWid TnPulse WidthShot Counter VolumeFmark GPIBAddr optionalPage Serial RS232 Pinout Command LanguageOkcrlf Command ProtocolCommunication Protocol Communication Commands Command ListDelays SpecificationsOutputs Replacing the Fuse MaintenancePage Long Pulse Option Specifications Custom Features