Command List
The following table summarizes all the commands:
9700 Communication Commands
Command Name | Parameters | Description | |
|
|
|
|
MODE | 0 | = Single Shot mode | Sets the pulse generator mode. |
| 1 | = External Trigger mode |
|
TRIG | 0 | = falling edge | Sets the active edge of the Ext/Gate signal when used as |
| 1 | = rising edge | an external trigger. |
T1:Ena | 0 | = Disable | Enable/disable Channel 1 |
| 1 | = Enable |
|
T1:Iamp | 0 | - 2500 | Sets the current level, in 10's of mA (100 = 1A), for |
|
|
| Channel 1 |
T1:Wid | 100 - 100000 | Sets the pulse width, in microseconds*10, for Channel 1. | |
|
|
|
|
T1:Dly | 0 | - 999999998 | Sets the delay, in microseconds*10, for Channel 1. |
|
|
|
|
T2:Ena | 0 | = Disable | Enable/disable Channel 2 |
| 1 | = Enable |
|
T2:Iamp | 0 | - 2500 | Sets the current level, in 10's of mA (100 = 1A), for |
|
|
| Channel 2 |
T2:Wid | 100 - 100000 | Sets the pulse width, in microseconds*10, for Channel 2 | |
T2:Dly | 0 | - 999999998 | Sets the delay, in microseconds*10, for Channel 2 |
|
|
|
|
BEEP | 1 | - 1000 | Beeps the speaker inside the 9700 the specified number |
|
|
| of times. |
RUN | 0 | = Disable | Enable / disables the pulse generator output. |
| 1 | = Enable |
|
RECALL | 0 | - 12 | Recall a stored configuration. |
|
|
|
|
STORE | 1 | - 12 | Store a configuration. |
|
|
|
|
SHOTS | 0 | = Reset to zero | Resets shot counter. SHOT ? will return the number of |
|
|
| shots. |
ECHO | 0 | = Disable | Enables/Disables the RS232 echo. The result string is |
| 1 | = Enable | always sent back. |
Fmark, | 0 | = , (comma) | Sets the character used as a decimal point on the display. |
| 1 | = . (period) |
|
VOLUME | 0 | - 9 | Sets the key click volume level. |
|
|
|
|
18