6. Set up
provided to fix the trimming mechanism into place.
(1)Shaft tube
(2)Trimming mechanishm
(3)Screw hole
(4)Bolt
(5)Fastening bolt
■BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.
(PS-EX only)
■ATTACHING THE PRUNING MECHANISM (SE1)
PS-EX SE3
PS-EX SE4
1. Loosen a nut and remove the chain cover.
2. Mount the guide bar then fit the saw chain around the bar and sprocket. (SE3)
U
S
WARNING
Pay attention to the correct direction of the saw chain
3.Fit the chain tensioner nut into the lower hole of the guide bar, then install the chain cover, and fasten the mounting nut to finger tightness. (SE3)(SE4)
(1)Hole
(2)Moving direction
(3)Chain tensioner nut
|
(1) |
(2) |
(3) |
(4) |
(5) |
1.Remove the cap on the end of the main pipe.
2.Remove the screw screwed into the end of the gear case.
3.Insert the end of the gear case into the main pipe.
4.Line up the hole on the end of the gear case into which the screw is to be inserted with the hole on the main pipe, and screw the screw firmly in.
5.Using a wrench, screw in the bolt provided to fix the mechanism into place.
PS-EX SE5
PS-EX SE6
4.Adjust the chain tension by turning the tensioner screw until the tie straps just touch the bottom side of the bar rail.
(SE5)
(1)Chain tension adjusting screw
(a) Loosen
(b) Tighten
5. Tighten the mounting nut securely with |
the bar tip held up (TORQUE: 8.9~11.7 |
N.m./90~120 |
PS-EX SE2
(1)Main pipe
(2)Gear case
(3)Screw hole
(4)Fastening bolt
(5)Bolt
A standard package contains the items as shown below. (SE2)
(1)Guide bar
(2)Saw chain
(3)Gase case
(4)Sprocket
(5)Chain tension adjust screw
(6)Nut
(7)Chain tensioner nut
(8)Chain cover
Install the guide bar and the saw chain on the gear case as follows.
chain for smooth rotation and correct |
tension while moving it by hand. If |
necessary, readjustment. (SE6) |
(1) Tighten
WARNING
It is very important to maintain the proper chain tension. Rapid wear of the guide bar or the chain coming off easily can be caused by improper tension. Especially when using a new chain, take good care of it since it should expand when first used.
■BALANCE UNIT
1.Put on strap and attach unit to strap.
2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.
WARNING
The saw chain has very sharp edges.
Use protective gloves for safety.