RedMax G3800AVS manual Operation, F10 F11, Starting Engine, Choke knob

7. Operation

F7

F8

F9

F10

F11

12 

WARNING

It is very dangerous to run a chainsaw that mounts broken parts or lacks any parts.

Before starting engine, make sure that all the parts including bar and chain are installed properly.

■STARTING ENGINE

1.Fill fuel and chain oil tanks respectively, and tighten the caps securely. (F7)

2.Put the switch to "I" position. (F8)

(1)	Chain oil	(2)	Fuel	(3) Switch
(4)	Throttle lever	(5)	Throttle interlock

3.Pull out the choke knob to the second-stage position. The choke will close and the throttle lever will then be set in the starting position [F10-(a)].

(6) Choke knob

NOTE

When restarting immediately after stopping the engin, Choke knob in the first-stage position (choke open and throttle lever in the starting position)

NOTE

Once the choke knob has been pulled out, it will not return to the operating position even if you press down on it with your finger. When you wish to return the choke knob to the operating position, pull out the throttle lever instead.

4.While holding the saw unit securely on the ground, pull the starter rope vigorously. (F11)

WARNING

Do not start the engine while hanging the chain saw with a hand. The saw chain may touch your body. It's very dangerous.

5.When engine has ignited first, puch in the choke knob to the first-stage position and pull the starter again to start the engine.

6.Allow the engine to warm up with the throttle lever pulled slightly.