RedMax G3800AVS manual Symbols on the machine, Engine Family 5KZXS Bcem

Page 5

3. Symbols on the machine

WARNING

For safe operation and maintenance, symbols are carved in relief on the machine.

According to these indications, please be careful not to take a mistake.

(a). The port to refuel the "MIX GASOLINE" Position: Fuel cap

(b). The port to refuel the chain oil Position: Oil cap

(c). Put the switch to the "O" position, immediately the engine stops. Position: Rear-left of the unit

(d). Starting the engine, if you pull out the choke knob (at the back- right of the rear handle) to the point of the arrow, you can set the starting mode as follows

First-stage position – starting mode when the engine is warm.

Second-stage position – starting mode when the engine is cool. Position: Upper-right of the aircleaner cover

(e). The screw under the "H" stamp is The High-speed adjustment screw.

The screw under the "L" stamp is The Slow-speed adjustment screw.

The screw at the left of the "T" stamp is the Idle adjustment screw.

Position: Left side of the rear handle

(f). It shows the directions that the chain brake is released (for the white arrow) and activated (for the black arrow).

Position: Front of the chain cover

IMPORTANT ENGINE INFORMATION

THIS ENGINE CONFORMS TO US EPA P H 1 F O R S M A L L O F F - ROA D E N G I N E S .

ENGINE FAMILY : 5KZXS. 0374BC:EM

ENGINE DISPLACEMENT : 37cc

REFER TO OWNER'S MANUMAL FOR MAINTE- NANCE SPECIFICATIONS AND ADJUSTMENTS.

MANUFACTURED :

RedMax Made in Japan

INFORMATION IMPORTANTE CONCERNANT LE MOTEUR

Ce moteur conformc aux normcs U.S. EPA PH1 pour les petits moteurs tout-terrain.

Type de moteur : 5KZXS. 0374BC:EM

Cylindrée du moteur : 37cc

Se référer au Manuel de l'utilisateur pour les spécifications d'entretien et les réglages.

Manufacturé :

RedMax Made in Japan

5

Image 5
Contents T2108-93110 G3800AVSPage Contents Safety FirstParts location SpecificationsG3800AVS Power unit Engine Family 5KZXS Bcem Symbols on the machineFor safe operation Kickback Safety Precautions for Chain SAW Users Moving Direction Installing guide bar and saw chainTensioner nut Chain cover Loosen Tighten Tensioner screw HOW to MIX Fuel When using Zenoah genuine oilFuel and Chain oil Recommended Mixing Ratio Gasoline 50OILChain OIL Fueling the UnitFor Your Engine LIFE, Avoid Operation Chain oil Fuel Switch Throttle lever Throttle interlockF10 F11 Starting EngineChecking OIL Supply Adjusting Carburetor F14Chain Brake How to confirmStopping Engine Switch Carburetor anti-freeze mechanismF17 F18 Choke knob Cylinder cover Icing cap HOW to Switch Between Operating Modes F19F19 Guard Against Kickback F21 SawingFelling a Tree F22 F22Cutting Limb of Fallen Tree F25 F23 F24 F25 F26 Log lying on the ground F23Log hanging off the ground F24 Maintenance After Each USE MaintenancePeriodical Service Points Champion F34 F35 Spark plug F34RCJ-7Y Sprocket F35SAW Chain Maintenance of Saw Chain and Guide BarF36 F37 Ruler Gap No gap Chain tilts F38 F39Guide BAR Case 3. Oil does not come out Troubleshooting GuideCase 2. Lack of power/Poor acceleration/Rough idling Storage Parts list G3800AVS  29   30   31   32   33  Chain Saws Limited Warranty RedMax Garantie limitée des tronçonneuses