RedMax HEZ2500S manual  19 , Operation, OP6 OP7, throttle set button, STOPPING ENGINE OP5

Page 19

OP6

8. Operation

OP5 (5)

(6)

(4)

(7)

OP6

OP7

.04 in

(1~2mm) (1)

rope quickly until engine fires. (OP6)

(1)choke lever (2) close (3) open

(4)ignition switch (5) start (6) stop

(7)throttle set button

IMPORTANT

•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

6.Move the choke lever downward to open the choke. And restart engine. (OP4)

7.Allow the engine to warm up for a several minutes before starting operation.

NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

■STOPPING ENGINE (OP5)

1.Release the throttle lever and run the engine for a half minute.

2.Shift the ignition switch to the STOP position.

IMPORTANT

•Except for an emergency, avoid stopping the engine while pulling the throttle lever.

■ADJUSTING THROTTLE CABLE

•The normal play is 1 or 2mm when measured at the carburetor side end. Readjust with the cable adjuster as required. (OP7)

(1) cable adjuster

19 

Image 19

Contents WARNING WARNING HEZ2500SSTICK EDGERS OWNER / OPERATOR MANUALPage SAFETY FIRST  4  1. Parts location 5  2. SpecificationsHEZ2500S  6  3. Warning labels on the machineINFORMATION IMPORTANTE CONCERNANT LE MOTEUR 4. Symbols on the machine 7  IMPORTANT ENGINE INFORMATIONWORKING CONDITION 5. For safe operation 8  4 Thick work gloves 5 Non-slip-sole work bootsWORKING PLAN  9 BEFORE STARTING THE ENGINE  10 STARTING THE ENGINE USING THE PRODUCT  11 MAINTENANCE  12 IF SOMEONE COMES HANDLING FUEL  13 TRANSPORTATION CONNECTING SWITCH WIRES 6. Set up 14  CONNECTING THROTTLE WIRE5 Cutter holder A  15 SE5 SE6 SE7 1 Blade mounting bolt Left-handed 2 Cutter holder B 3 Blade 4 Bar 16  7. FuelFUELING THE UNIT  17 FOR YOUR ENGINE LIFE, AVOID ADJUSTING WHEEL HEIGHT 8. Operation 18  ADJUSTING HANDLE POSITION1 cable adjuster  19 1 choke lever 2 close 3 open 4 ignition switch 5 start 6 stop ADJUSTING THROTTLE CABLEADJUSTING IDLING SPEED OP8  20 BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER 9. Maintenance 21  Things to check before using stick edgerAIR FILTER  22 MA51  23 PROCEDURES TO BE PERFORMED AFTER EVERY 100 HOURS OF USE  24 1 cylinder 2 intake air cooling vent back  25  10. Storage 26  11. Troubleshooting guide 27  12. Parts listFig.1 DRIVE UNIT HEZ2500S S/N 000000 and up  28 Key#  29 Fig.2 ENGINE UNIT HEZ2500S S/N 015257 and up  30  31  Owner’s warranty responsibilities CALIFORNIA EMISSION CONTROL WARRANTY STATEMENTYOUR WARRANTY RIGHTS AND OBLIGATIONS Manufacturer’s warranty coverageKOMATSU ZENOAH AMERICA INC RedMax STICK EDGER MODEL HEZ2500S 2-YEAR LIMITED WARRANTY4344 Shackleford Road Suite Norcross, Georgia limites de la garantie RedMax STICK EDGER Modèle HEZ2500S Garantie limitée à 2 ansIl nexiste aucune autre garantie explicite Page Norcross, Georgia KOMATSU ZENOAH AMERICA INC 4344 Shackleford Road SuitePrinted in Japan