RedMax HEZ2500S manual For safe operation,  8 , Working Condition, Working Circumstance

Page 8
5. For safe operation

5. For safe operation

1.Read this manual carefully until you completely understand and follow all safety and operating instructions.

2.Keep this manual handy so that you may refer to it later whenever any questions arise. Also note, if you have any questions which cannot be answered herein, contact the dealer from whom you purchased the product.

3.Always be sure to include this manual when selling, lending, or otherwise transferring the ownership of this product.

4.Never allow children or anyone unable to fully understand the directions given in the manual to use the machine.

WORKING CONDITION

1.When using the product, you should wear proper clothing and protective equipment.

(1)Helmet

(2)Ear protectors

(3)Protection goggles or face protector

(4)Thick work gloves

(5)Non-slip-sole work boots

2.And you should carry with you.

(1)Attached tools and files

(2)Properly reserved fuel

(3)Spare blade

(4)Things to notify your working area (rope, warning signs)

(5)Whistle (for collaboration or emergency)

(6)Hatchet or saw (for removal of obstacles)

3.Do not wear loose clothing, jewelry, short trousers, sandals, or go barefoot. Do not wear anything which might be caught by a moving part of the unit. Secure hair so it is above shoulder length.

WORKING CIRCUMSTANCE

1. Never start the engine inside a closed room or building. Exhaust gases contain dangerous carbon monoxide.

2. Never use the product,

a. when the ground is slippery or when you can’t maintain a steady posture.

8

Image 8
Contents HEZ2500S STICK EDGERSOWNER / OPERATOR MANUAL WARNING WARNINGPage SAFETY FIRST 1. Parts location  4 HEZ2500S 2. Specifications 5  3. Warning labels on the machine  6 4. Symbols on the machine  7 IMPORTANT ENGINE INFORMATION INFORMATION IMPORTANTE CONCERNANT LE MOTEUR5. For safe operation  8 4 Thick work gloves 5 Non-slip-sole work boots WORKING CONDITION 9  WORKING PLANSTARTING THE ENGINE  10 BEFORE STARTING THE ENGINE  11  USING THE PRODUCTIF SOMEONE COMES  12 MAINTENANCE TRANSPORTATION  13 HANDLING FUEL 6. Set up  14 CONNECTING THROTTLE WIRE CONNECTING SWITCH WIRES 15  SE5 SE6 SE71 Blade mounting bolt Left-handed 2 Cutter holder B 3 Blade 4 Bar 5 Cutter holder A7. Fuel  16 FOR YOUR ENGINE LIFE, AVOID  17 FUELING THE UNIT 8. Operation  18 ADJUSTING HANDLE POSITION ADJUSTING WHEEL HEIGHT 19  1 choke lever 2 close 3 open 4 ignition switch 5 start 6 stopADJUSTING THROTTLE CABLE 1 cable adjuster 20  ADJUSTING IDLING SPEED OP89. Maintenance  21 Things to check before using stick edger BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER 22  AIR FILTER 23  MA511 cylinder 2 intake air cooling vent back  24 PROCEDURES TO BE PERFORMED AFTER EVERY 100 HOURS OF USE 10. Storage  25 11. Troubleshooting guide  26 12. Parts list  27  28  Fig.1 DRIVE UNIT HEZ2500S S/N 000000 and up 29  Key# 30  Fig.2 ENGINE UNIT HEZ2500S S/N 015257 and up 31  CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONSManufacturer’s warranty coverage Owner’s warranty responsibilities4344 Shackleford Road Suite Norcross, Georgia RedMax STICK EDGER MODEL HEZ2500S 2-YEAR LIMITED WARRANTYKOMATSU ZENOAH AMERICA INC Il nexiste aucune autre garantie explicite RedMax STICK EDGER Modèle HEZ2500S Garantie limitée à 2 anslimites de la garantie Page Printed in Japan KOMATSU ZENOAH AMERICA INC 4344 Shackleford Road SuiteNorcross, Georgia