RedMax HEZ2500S manual  23 , Maintenance, MA51

Page 23
MA5(1)

9. Maintenance

MA4

(1)

MA5(1)

(2)

MUFFLER

23  WARNING

Inspect periodically, the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.

Note that failing to do so may result in the engine catching on fire.

SPARK ARRESTER

The muffler is equipped with a spark arrester to prevent red hot carbon from flying out of the exhaust outlet. Periodically inspect and clean as necessary with a wire brush. In the State of California it is required by law (Section 4442 of the California Public Resources Code) to equip a spark arrester when a gas powered tool is used in any forest covered, brush covered, or grass covered unimproved land. (MA4)

(1) spark arrester

INTAKE AIR COOLING VENT

Manual background WARNING

Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns.

When checking the machine to make sure that it is okay before using it, check the area around the muffler and remove any wood chips or leaves which have attached themselves to the stick edger. Failing to do so could cause the muffler to become overheated, and that this in turn could cause the engine to catch on fire. Always make sure that the muffler is clean and free of wood chips, leaves, and other waste before use.

Check the intake air cooling vent and the area around the cylinder cooling fins after every 25 hours of use for blockage, and remove any waste which has attached itself to the stick

23

Image 23
Contents WARNING WARNING HEZ2500SSTICK EDGERS OWNER / OPERATOR MANUALPage SAFETY FIRST  4  1. Parts locationHEZ2500S 2. Specifications 5   6  3. Warning labels on the machineINFORMATION IMPORTANTE CONCERNANT LE MOTEUR 4. Symbols on the machine 7  IMPORTANT ENGINE INFORMATIONWORKING CONDITION 5. For safe operation 8  4 Thick work gloves 5 Non-slip-sole work bootsWORKING PLAN  9 STARTING THE ENGINE  10 BEFORE STARTING THE ENGINE USING THE PRODUCT  11 IF SOMEONE COMES  12 MAINTENANCE TRANSPORTATION  13 HANDLING FUEL CONNECTING SWITCH WIRES 6. Set up 14  CONNECTING THROTTLE WIRE5 Cutter holder A  15 SE5 SE6 SE7 1 Blade mounting bolt Left-handed 2 Cutter holder B 3 Blade 4 Bar 16  7. FuelFOR YOUR ENGINE LIFE, AVOID  17 FUELING THE UNIT ADJUSTING WHEEL HEIGHT 8. Operation 18  ADJUSTING HANDLE POSITION1 cable adjuster  19 1 choke lever 2 close 3 open 4 ignition switch 5 start 6 stop ADJUSTING THROTTLE CABLEADJUSTING IDLING SPEED OP8  20 BE SURE TO CHECK THE FOLLOWING BEFORE USING YOUR STICK EDGER 9. Maintenance 21  Things to check before using stick edgerAIR FILTER  22 MA51  23 1 cylinder 2 intake air cooling vent back  24 PROCEDURES TO BE PERFORMED AFTER EVERY 100 HOURS OF USE  25  10. Storage 26  11. Troubleshooting guide 27  12. Parts listFig.1 DRIVE UNIT HEZ2500S S/N 000000 and up  28 Key#  29 Fig.2 ENGINE UNIT HEZ2500S S/N 015257 and up  30  31  Owner’s warranty responsibilities CALIFORNIA EMISSION CONTROL WARRANTY STATEMENTYOUR WARRANTY RIGHTS AND OBLIGATIONS Manufacturer’s warranty coverage4344 Shackleford Road Suite Norcross, Georgia RedMax STICK EDGER MODEL HEZ2500S 2-YEAR LIMITED WARRANTYKOMATSU ZENOAH AMERICA INC Il nexiste aucune autre garantie explicite RedMax STICK EDGER Modèle HEZ2500S Garantie limitée à 2 anslimites de la garantie Page Printed in Japan KOMATSU ZENOAH AMERICA INC 4344 Shackleford Road SuiteNorcross, Georgia