McCulloch MCB2203 Assembly Instructions Operating Instructions, Blower Attachment Assembly

3 - ASSEMBLY INSTRUCTIONS

4 - OPERATING INSTRUCTIONS

Remove blower from carton and examine it thoroughly to make sure it is not damaged. This electric blower requires no tools for assembly. Read your User manual carefully before assembly and operation.

3-1. BLOWER ATTACHMENT ASSEMBLY

1.Pull the blower tube (A) from (B), till it’s engaged. (Fig. 3-1A)

2.With a slight twisting motion, slide the larger width end of the blower tube, with the cut-out notch on top, into the blower outlet until it clicks in place.

3.To pull out the blower tube just press the red button

(C) and the blower tube will pull out. (Fig. 3-1C)

B

A

C

3-1C

4-1. EXTENSION CORD

MINIMUM WIRE GAUGE RECOMMENDATIONS

VOLTS	EXTENSION CORD	WIRE SIZE
	LENGTH	REQUIRED
	25 feet / 7.5m	18 A.W.G.*
120	50 feet / 15m	16 A.W.G.*
	100 feet / 30m	16 A.W.G.*

*American Wire Gauge

Table 1

1.	When using the power blower, an extension cord of
	adequate size must be used for safety, and to prevent
	loss of power and overheating. See Table 1.
2.	The extension cord must be specifically designed for
	outdoor use and marked “SW-A”, “SOW-A”, “STW-A”,
	“STOW-A”, “SJW-A”, “SJOW-A”, “SJTOW-A”, “SJTW-
	A”, or “SJTW”.
3.	Inspect extension power cord for loose or exposed
	wires and damaged insulation. If damaged, replace
	before using power blower.
4.	To reduce the risk of electric shock, this power blower
	has a polarized plug (one blade is wider than the
	other). This plug will fit in a polarized extension cord
	only one way. If the plug does not fit fully in the exten-
	sion cord, reverse the plug. If it still does not fit, do not
	use that extension cord. Do not change the plug in

4-2. OPERATING TIPS

1.Always work moving away from solid objects such as walls, large stones, automobiles and fences.

2.Clean spaces with corners by starting in corners and moving outward to straight areas to prevent an accu- mulation of debris which could fly into face.

3.Be careful when working near valuable plants. The force of air could damage tender plants.

4.Uses for your blower:

•Sweeping debris or grass clippings from driveways, sidewalks, patios, parks, parking lots, barns, etc.

•Gathering grass clippings, straw or leaves into piles.

•Removing debris from corners, around joints and between bricks.

4-3. SWITCH

Press “o” Off, “1” Low Speed, “2” High Speed. (Fig. 4-3A)

Switch

3-1A

3-1B

any way.

5. Secure the extension cord (A) to the power supply

cord (B) as shown in Figure 4-1A. Devices for retain-

ing extension cords may also be obtained at your local

hardware store.

B

A

4-1A

4-3A

6

7