Recording Function on CD-2, Recording Mode

-The CD burner is mainly designed for recording purposes. After recording, the recorded disc may be played back in CD 2, but it is only for checking your recording before finalizing. Please note that the first few seconds of the recording may not play in the CD 2 tray. We recommend only using the CD 1 tray (CD1/AUX mode) for normal CD playback.

RECORDING FUNCTION ON CD-2

Apart from the CD playback function, CD 1, PHONOGRAPH, TAPE or AUX

CD-2can perform the CD recording function either from modes. All tracks will be stored in “AUDIO-CD“ format.

Before starting, place a blank CD-R or CD-RW disc onto the CD-2tray. The disc will be able to be recorded on if the LCD display shows the “NO TOC “indicator.

NOTE: A CD-R disc can only be recorded once and does not support erase or re-record function. The playback quality of CD-R/RW discs vary depending on the type of audio CD player they are used in.

Important Notices:

-The revolving speed of CD-2(CD Burner) is higher than a normal CD mechanism. Some mechanical noise and vibration of the cabinet may occur during operation. This is not a malfunction of the system.

-Quality and compatibility of CD-R/RW discs on the market varies. Please change to another brand if you are having problems burning a specific type or brand of disc.

A)RECORDING MODE

I)CD RECORDING i) Manual Recording

1)Press the “CD 1/AUX” button on unit front panel to enter mode. Place a source CD

inside the tray.

2)Load a recordable CD-R/RW disc into CD-2tray. Press the “REC “ button and then the CD “PLAY/PAUSE ” button on CD-2until the recording indicator “ “ shows on LCD display.

3)After few seconds, the LCD will show the time counter notifying you that the system is

recording. Now start the playback of the CD in tray.

4)During the recording process, you can record a desired session by pressing the track separation “” button. A new CD track will be created and continue recording the next session (track).

5)When the recording is completed, press the “STOP ” button on CD-2and then stop the

playback of .

ii) Recoding by Program

1)Press the “CD 1/AUX“ button to enter mode. Place a source CD inside tray in STOP mode.

2)Select the desire tracks by following the “CD Disc Programming “ procedures.

3)Repeat the same procedures from step 2 to 5 as described on part A-I-i from above (manual recording) to complete the recording process.

II) PHONOGRAPH RECORDING

1)Press the PHONO function button on the unit front panel to enter “PHONO “mode. Place the record on the turntable and get ready for playback.

2)Press the “REC “ button and then the CD “ PLAY/PAUSE ” button on CD-2until the recording indicator “ “ shows on LCD display.

3)After few seconds, the LCD will show the time counter and the system is now recording. Now start the playback of the record in PHONO mode.

4)During the recording process, you can record a desired session by pressing the track separation “” button. A new CD track will be created and continue recording the next session (track).

5)After completion of recording, press the “STOP ” button at CD-2and then stop the playback of the record.