Husqvarna SMC 50 EF manual Install scale pointer and scale FIG, Install the handlebar FIG

Page 19

INSTALLATION

One-man sawmill with chain saw engine

Install the handlebar (FIG. 32)

The handlebar with the throttle is installed on the saw carriage using two bolts.

Install throttle and cable (FIG. 33)

The throttle and lever are installed in the chain saw’s handle. The loop (A) is positioned inside the handle. The washers (B and C) are screwed into position.

When the throttle’s mounting is installed, the throttle lock on the saw is pressed in. Connect the cable from the handlebar into the lever and adjust it using the screw nipple. When the throttle on the handlebar is not activated, the play between the throttle on the saw and the lever (D) should be approximately 1 mm.

Install scale pointer and scale (FIG. 34)

Install the scale pointer and scale as follows:

1.The scale pointer is installed using two self-tapping screws (A).

2.Insert the scale through the scale pointer from above. The scale’s greatest value should point downwards. Screw the scale into the saw carriage

3.Measure the distance between the lower part of the saw chain (D) and the log bolster. Set the scale pointer so that the scale has the same value.

4.Bolt on the scale pointer.

5.Check that the saw chain moves freely over the long

(E)and short (C) log supports when the red mark can be read on the scale.

FIG. 32

FIG. 33

A

B

C

D

1 mm

FIG. 34

E

A

C

B

D

English – 19

Image 19

Contents English SMC 50 SMC 50 E SMC 50 EFTable of Contents Introduction IntroductionSymbols KEY to SymbolsSafety Regulations Safety RegulationsPersonal Protective Equipment Risk Zone One-man Sawmill Safety EquipmentFuel Safety Safety During UseOne-man sawmill chain saw engine DescriptionOne-man Sawmill Electric Motor One-man sawmill with electric motor and feed Handlebars FIG Height Setting FIGSaw carriage FIG Frame and FIGFeed unit for chain sawmill with electric motor FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Bar and chain FIGElectric motor feed unit FIG MotorsChain saw engine FIG Electric Motor FIGFolding Stops C Height Adjustment BRails Log Bolsters aRail Stop Adjustable Support FeetRail Guard Safety Devices Unpacking InstallationInstallation Installation SiteSaw Carriage Adjustment FIG Setting up the Saw Carriage FIGOne-man sawmill with electric motor Install chain saw and bar FIGInstall the bar FIG One-man sawmill with chain saw engineInstall the handlebar FIG Install scale pointer and scale FIGInstall throttle and cable FIG Checking the bar Adjusting the barFuel chain saw engine Fuel HandlingPetrol Mixing Two-stroke oilFuelling Starting a cold chain saw engine FIG Starting and StoppingStopping the chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIGSecuring the Log USESawing Calculating the YieldStarting the Electric Motor Starting the Petrol EngineEdging FIG Clutch drum MaintenanceSaw chain Drive belt Saw unit’s height adjustmentMonthly maintenance MaintenanceDaily maintenance Weekly maintenanceTechnical data Technical DataVibration Levels Noise LevelsEU Declaration of Conformity only applies to Europe Page 2004W12 114 02