Husqvarna SMC 50 EF manual Use, Securing the Log

Page 25

USE

Securing the Log

!WARNING!

Exercise care during all log hand- ling. Heavy lift! Wear boots or shoes fitted with steel toecaps.

1.Fold up the stops (C) on the left-hand side of the rails.

2.Roll the log up against either the long or the short log support, depending on the timber dimensions.

• than 300 mm to the end of the rails

• than 500 mm to the start of the rails

This means that when using two rail sections, the maximum log length is 5200 mm.

3.Raise the log using the log lifter (B) so that the log’s core is horizontal.

4.Lock the log in position with the log lock (D).

FIG. 43

FIG. 44

English – 25

Image 25

Contents English SMC 50 SMC 50 E SMC 50 EFTable of Contents Introduction IntroductionSymbols KEY to SymbolsSafety Regulations Safety RegulationsPersonal Protective Equipment Fuel Safety One-man Sawmill Safety EquipmentSafety During Use Risk ZoneOne-man sawmill chain saw engine DescriptionOne-man Sawmill Electric Motor One-man sawmill with electric motor and feed Saw carriage FIG Height Setting FIGFrame and FIG Handlebars FIGVibration damping plate for the chain saw FIG Chain oil tank FIGBar and chain FIG Feed unit for chain sawmill with electric motor FIGChain saw engine FIG MotorsElectric Motor FIG Electric motor feed unit FIGRails Height Adjustment BLog Bolsters a Folding Stops CRail Stop Adjustable Support FeetRail Guard Safety Devices Installation InstallationInstallation Site UnpackingSaw Carriage Adjustment FIG Setting up the Saw Carriage FIGInstall the bar FIG Install chain saw and bar FIGOne-man sawmill with chain saw engine One-man sawmill with electric motorInstall the handlebar FIG Install scale pointer and scale FIGInstall throttle and cable FIG Checking the bar Adjusting the barFuel chain saw engine Fuel HandlingPetrol Mixing Two-stroke oilFuelling Starting a cold chain saw engine FIG Starting and StoppingStopping the chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIGSecuring the Log USESawing Calculating the YieldStarting the Electric Motor Starting the Petrol EngineEdging FIG Clutch drum MaintenanceSaw chain Drive belt Saw unit’s height adjustmentDaily maintenance MaintenanceWeekly maintenance Monthly maintenanceTechnical data Technical DataVibration Levels Noise LevelsEU Declaration of Conformity only applies to Europe Page 2004W12 114 02