Husqvarna 333R Assembly, Assembling the handlebar and throttle, Fitting blades and trimmer heads

Page 12

ASSEMBLY

Assembling the handlebar and throttle

•Remove the screw at the rear of the throttle handle.

•Slide the throttle handle onto the right side of the handlebar, (see diagram).

•Align the screw hole in the throttle handle with the hole in the handlebar.

•Refit the screw in the hole in the rear of the throttle handle.

•Screw the screw through the handle and handlebar. Tighten it.

RX R

•Fit the mounting components as shown.

•Loosely tighten the four screws. (R)

•Put on the harness and hang the machine from the support hook. Now make a final adjustment so that the machine is in a comfortable working position when it hangs from the harness.

•Tighten the knob. (RX)

Fitting blades and trimmer heads

WARNING!

! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting attachment

!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting the guard extension

CAUTION! The guard extension shall always be fitted when using the trimmer head/plastic blades and combination guard. The guard extension shall always be removed when using the grass blade and combination guard.

Enter the guard extension guide in the slot of the combination guard. Then click the guard extension into position on the guard with the four quick-fasteners.

The guard extension is removed easily using the spark plug spanner, see illustration.

12 – English

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 333R 335RX-series KEY to Symbols SymbolsContents Introduction Dear customerWhat is WHAT? What is what on the clearing saw?General Safety Precautions Personal protective equipmentMachine′s safety equipment Stop switchThrottle lock Cutting attachment guardVibration damping system Quick releaseMuffler Cutting equipment Locking nutCutting equipment Sharpening grass cutters and grass bladesSharpening the saw blade Trimmer head Assembly Assembling the handlebar and throttleFitting blades and trimmer heads Fitting the guard extensionFitting a blade guard, grass blade and grass cutter Fitting the blade guard and saw bladeFitting other guards and cutting attachments Fitting a trimmer guard and Superauto II 1 trimmer headAdjusting the harness and clearing saw Standard harnessSpreading the load on your shoulders Correct heightFuel safety Fuel HandlingFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingFor throttle handles with a start throttle lock StoppingBasic safety rules Working TechniquesGeneral working instructions ABC of clearingForestry clearing using a saw blade Working methodsGrass clearing using a grass blade Brush cutting with a saw bladeGrass trimming with a trimmer head Clearing Maintenance CarburetorCorrectly adjusted carburetor Adjusting the start throttle speedMuffler High speed jet HCleaning the air filter Cooling systemBevel gear Air filterSpark plug Sharpening grass cutters and grass bladesSharpening the saw blade Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataApproved accessories Type Cutting attachment guard, Art. no Federal Emission Control Warranty Statement Your Warranty Rights and ObligationsSuper Auto Super Auto II Page S35 25 m T35 Page ´z+HAe¶5f¨ Page 1140336-95 ´z+HAe¶5f¨ ´z+HAe¶5f¨
Top Page Image Contents