Husqvarna 333R, 335R manual Fitting other guards and cutting attachments

ASSEMBLY

•When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade.You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut.

Fitting a trimmer guard and Superauto II 1" trimmer head

LK

G

K F

I B

J C

I

A

• Fit the correct trimmer guard (A) for use with the trimmer

head. CAUTION! Ensure that the guard extension is

fitted.

Hook the trimmer guard/combination guard onto the fitting

•To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

•Fit the bottom half of the trimmer head (K) to the cover (I) by pressing them together, with the cut-outs on the bottom half aligned with the catches on the cover.

•To dismantle, follow the instructions in the reverse order.

Fitting other guards and cutting attachments

•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. CAUTION! Ensure that the guard extension is fitted.

Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.

L

	on the shaft and secure with the bolt (L).
• Fit the drive disc (B) on the output shaft.
•	Turn the blade shaft until one of the holes in the drive disc
	aligns with the corresponding hole in the gear housing.
•	Insert the locking pin (C) in the hole to lock the shaft.

M

A

C

• To fit the trimmer head, first separate the two halves (see

diagram). Proceed as follows:

- Insert a finger into the centre hole of the cover (I) while

grasping the cover with your other fingers. Using the

index finger and thumb of your other hand, release the

two catches (J) that engage in the cut-outs in the

bottom half (K). Pull apart the trimmer head, grasping

the cover firmly.

• Place the cover (I) and the support flange (F) on the

output shaft.

• Fit the nut (G). Tighten the nut to a torque of 35-50 Nm

(3.5-5 kpm). Use the socket spanner in the tool kit. Grasp

the handle of the spanner as close to the trimmer guard

as possible.

•Fit the drive disc (B) on the output shaft.

H

BA

M L

• Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

• To dismantle, follow the instructions in the reverse order.

14 – English