Husqvarna 426LST, 430LS manual Assembly, Fitting the loop handle, Assembling the cutting equipment

Page 10

ASSEMBLY

Fitting the loop handle

Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.

Slide the spacer into the slot in the loop handle. Fit the nut and screw. Tighten.

Assembling the cutting equipment

WARNING! Never use a cutting

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

Fitting the trimmer guard and trimmer head

Fit the correct trimmer guard (A) for use with the trimmer head.

A

Tighten the two screws.

Fit the drive disc (B) on the output shaft.

Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

Insert the locking pin (C) in the hole to lock the shaft.

Screw on the trimmer head (D) in the opposite direction to the direction of rotation.

10 – English

Image 10
Contents 426LST 430LS EnglishOperator of the machine must Ensure, while working, that no KEY to SymbolsSymbols Persons or animals come closerContents Introduction Dear customerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentStop switch Machine′s safety equipmentThrottle lockout Cutting attachment guard MufflerCutting equipment Trimmer headAssembling the cutting equipment AssemblyFitting the loop handle Fitting the trimmer guard and trimmer headFuel Handling Fuel safetyFuel Fueling MixingStarting and stopping Starting and StoppingCheck before starting StartingStopping Working Techniques Basic safety rulesGeneral working instructions Basic working techniques Grass trimming with a trimmer headMuffler MaintenanceCarburetor Cooling systemBevel gear Fuel filterAir filter Must always be replacedMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataYour Warranty Rights and Obligations Emission Warranty Parts List T25 S35 25 m T35, T35x Page 1153174-95