ASSEMBLY
Assembly requires two people. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Read through all steps before beginning. During assembly, make sure that all parts are oriented as shown in the drawings.
Assembly requires the included tool and grease packet as well as an adjustable wrench 
,
a rubber mallet 
, and a phillips screwdriver 
.
Use the drawings below to identify the small hardware used in assembly. The number in parenthesis beneath each part refers to the key number of the part, from the PART LIST on page 10. The second number refers to the quantity used in assembly. Note: some of the hardware shown below may have been
M8 Spring Washer (3)Ð4 | M8 Locknut | 3/8" Push Cap |
|
|
M8 Washer | 1/2" Locknut | 5/8" Push Cap |
|
|
M6 x 16 Screw
Link Arm Bushing
Pedal Bushing
3/16Ó Small Screw (2)Ð15
1.Press an Endcap (40) onto each of the two Frame Extensions (65). Press the Frame Extensions (65) into the Frame (1) as shown.
1 |
40 |
65 |
1 |
65 |
40 |
4
