Sears 831.288264 TROUBLE-SHOOTING and Maintenance, Electronic Monitor, Tightening the Pedals

Follow the steps below to use the electronic monitor:

1.To turn on the power, press the on/off button or simply begin pedaling.

2.Select one of the five modes:

A. ScanÑ	Mode indicators
When the
power is
turned on,
the scan
mode will
be select-
ed auto-
matically.

Amode indicator will appear by the

word "SCAN." The speed, time, distance and calo- rie modes will all be displayed, for five seconds

each, in a repeating cycle. A second mode indica- tor will show which mode is currently displayed.

B. Speed, time, distance or calorieÑTo stop the scan mode and select the speed, time, distance or calorie mode for continuous display, repeatedly press the mode button. Make sure that there is not a mode indicator by the word ÒSCAN.Ó The modes will be selected in the following order: speed, time, distance, calorie, scan.

3.To reset the display, turn the power off and then on again by pressing the on/off button twice.

4.When you are finished exercising, press the on/off button to turn off the power. Note: If the pedals are not moved and the buttons are not pressed for four minutes, the power will turn off auto- matically in order to conserve the batteries.

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts of the exercise cycle regu- larly. To clean the exercise cycle, use a damp cloth and mild detergent. Never use abrasives or solvents; keep liquid away from the console.

ELECTRONIC MONITOR

If the electronic monitor does not function properly, the batteries should be replaced. Most problems are the result of drained batteries. See assembly step 4 on page 5 for battery installation instructions.

If the electronic monitor still does not function properly, the sensor wire should be checked. See assembly step 4 on page 5. Slide the electronic monitor off the frame and make sure that the sensor wire is plugged fully into the wire on the electronic monitor.

TIGHTENING THE PEDALS

If the pedals become loose, tighten the pedal shafts into the arms of the crank. Tighten the 1/2Ó Locknuts onto the pedal shafts (see assembly step 7 on page 6).

ADJUSTING THE CHAIN

The exercise cycle features a precision chain that must be kept properly lubricated and adjusted. Apply a few drops of light multi-purpose oil to the chain every three months. If the chain is too tight, the bearings may be damaged; if the chain is too loose, the fan may be

damaged. If the chain causes excessive noise or slips as you pedal, check the chain in the following way:

1.Carefully pry the Access Cover (14) off the right side shield. Reach into the access hole and press down on the chain. There should be no more than 1 inch, and no less than 1/4 inch, of verti- cal movement in the center of the chain. If the chain is properly adjusted, reattach the Access Cover. If the chain needs to be adjusted, see step 2.

14

4

8

2.Pry the Access Cover (14) off the left side shield. Loosen the M8 Washer Nuts (4). To tighten the chain, turn the M6 Adjustment Nuts (8) clockwise; to loosen the chain, turn the Adjust-ment Nuts counterclockwise. Make sure that the fan is straight, tighten the Fan Nuts and reattach the Access Covers.

8