ASSEMBLY
Fitting other guards and cutting attachments (235R)
•Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. CAUTION! Ensure that the guard extension is fitted.
Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.
H
L
M
C B
A
AM L
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.
H
H
•To dismantle, follow the instructions in the reverse order.
Adjusting the harness and clearing saw
WARNING! When using a clearing saw it ! must always be hooked securely to the harness. Otherwise you will be unable to
control the clearing saw safely and this can result in injury to yourself or others. Never use a harness with a defective quick release.
Quick release
At the front is an easily accessible, quick release. Use this if the engine catches fire or in any other emergency situation that requires you to free yourself from the machine and harness.
Spreading the load on your shoulders
A
Correct height
1Forestry clearing
Adjust the support strap so that the support hook is around 10 cm below your hip. The blade should be angled forward a little.
2Grass clearing
The support hook should hang around 20 cm below your hip so that the blade is parallel to the ground.
Correct balance
1Forestry clearing
Move the suspension ring on the machine forward or backward. It is easier to avoid sawing into the ground if the blade is balanced a few dm above the ground.
2Grass clearing
Let the blade balance at a comfortable cutting height, i.e. close to the ground.
English – 17