Husqvarna 323C manual General rules

Page 7

SAFETY INSTRUCTIONS

•Regularly check that the muffler is securely attached to the machine.

•If the muffler on your machine is fitted with a spark arrestor mesh then it should be cleaned regularly. A blocked mesh causes the engine to overheat, which can lead to serious damage. Never use a muffler with a defective spark arrestor mesh.

Cutting equipment

This section describes how to choose and maintain your cutting equipment in order to:

•Obtain maximum cutting performance.

•Extend the life of cutting equipment.

General rules

1Only use cutting attachments with the guards we recommend! See the chapter on Technical data.

2Check the cutting attachment for damage or cracks. A damaged cutting attachment should always be replaced.

Locking nut

•When fitting, tighten the nut in the opposite direction to the direction of rotation of the cutting attachment. To remove it, undo the nut in the same direction as the cutting attachment rotates. (CAUTION! The nut has a left-hand thread.)

•Tighten the nut using the socket spanner. 35-50 Nm (3.5- 5 kpm).

CAUTION! The nylon lining inside the locking nut must not be so worn that you can turn it by hand. The lining should offer a resistance of at least 1.5 Nm. The nut should be replaced after it has been put on approx. 10 times.

WARNING! Never use a machine with faulty

!safety equipment. The machine’s safety equipment must be checked and maintained as described in this section. If your machine fails any of these checks contact your service agent to get it repaired.

English – 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 323C 325CX 323L 325LX 325LDX Symbols KEY to SymbolsContents Machine′s safety equipment Safety InstructionsPersonal protective equipment Locking nut Vibration damping systemMuffler Cutting equipmentNever use a machine that has a faulty muffler General rules Starting General safety precautionsCutting equipment Trimmer headTransport and storage Fuel safetyBasic safety rules General working instructionsBasic working techniques Grass trimming using a trimmer head and plastic bladesWhat is what? What is WHAT?Fitting the trimmer head AssemblyFitting the loop handle 323C, 325Cx Assembling and dismantling the two-piece shaft 325LDxAssembly Fitting the trimmer guard and trimmer head 325Cx Fitting the trimmer guard and trimmer head 323CGuard Two-stroke oil Fuel HandlingFuel GasolineFuelling Cold engine Starting and StoppingCheck before starting Starting and stoppingStopping Warm engineCarburettor MaintenanceHigh speed jet H Fine adjustment of the idle speed TCorrectly adjusted carburettor MufflerTwo-piece shaft Cleaning the air filterCooling system Spark plugMaintenance schedule Technical data Technical DataTechnical data 325Lx 325LDx Engine Attachments Art No Use with Your Warranty Rights and Obligations Federal Emission Control Warranty StatementSuper Auto Super Auto II Tri Cut Trimmy H Click Trimmy Hit Junior Trimmy Hit Pro S35 25 m T35 Trimmy Page ´z+H43¶5.¨ Page 1140201-95
Top Page Image Contents