Ryobi CS30 RY30524, SS30 RY30544 manual Fueling and Refueling the Trimmer, Operating the Trimmer

Page 15

OPERATION

FUELING AND REFUELING THE TRIMMER

FUEL MIXTURE

This product is powered by a 2-cycle engine and requires pre-mixing gasoline and 2-cycle oil. Pre-mix unleaded gaso- line and 2-cycle engine oil in a clean 1 gallon container ap- proved for gasoline.

Recommended fuel: This engine is certified to operate on unleaded gasoline intended for automotive use.

Mix a high quality 2-cycle engine oil at 2.6 oz. per gallon (US).

Do not use automotive oil or 2-cycle outboard oil.

DO NOT mix quantities larger than usable in a 30 day period.

HIGH QUALITY 2-CYCLE ENGINE OIL

GASOLINE

OIL

 

 

1 gallon (US)

2.6 oz.

1 liter

20 cc (20 ml)

FILLING TANK

Clean surface around fuel cap to prevent contamination.

Loosen fuel cap slowly. Rest the cap on a clean surface.

Carefully pour fuel into the tank. Avoid spillage.

Prior to replacing the fuel cap, clean and inspect the gasket.

Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage.

NOTE: It is normal for smoke to be emitted from a new engine after first use.

WARNING:

Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. from refueling site before starting engine. Do not smoke!

OPERATING THE TRIMMER

See Figure 15.

WARNING:

Always position the unit on the operator’s right side. The use of the unit on the operator’s left side will expose the user to hot surfaces and can result in possible burn injury.

WARNING:

To avoid burns from hot surfaces, never operate unit with the bottom of the engine above waist level.

Hold the trimmer with your right hand on the rear handle and your left hand on the front handle. Keep a firm grip with both hands while in operation. Trimmer should be held at a com- fortable position with the rear handle about hip height.

Always operate trimmer at full throttle. Cut tall grass from the top down. This will prevent grass from wrapping around the shaft housing and string head which could cause damage from overheating. If grass becomes wrapped around the string head, STOP THE ENGINE, disconnect the spark plug wire, and remove the grass. Prolonged cutting at partial throttle will result in oil dripping from the muffler.

PROPER

OPERATING

POSITION

Fig. 15

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRead ALL Instructions General Safety RulesSpecific Safety Rules Specific Safety Rules for Trimmer USESpecific Safety Rules for BRUSH- Cutter and Blade USE Symbol Name Explanation SymbolsSymbol Signal Meaning ServiceString Head Coupler Throttle TriggerFeatures CouplerKnob Assembly See Figure Installing the Power Head to the AttachmentRemoving the Attachment from the Power Head Attaching the Storage HangerFlat Washer Attaching the Front Handle CS30 and SS30Attaching the J Handle BC30 Front Handle Bolt Wing NUT ClampAttaching the Brushcutter Guard BC30 Attaching the Grass DeflectorTo Attach the Curved Shaft Grass Deflector CS30 To Attach the Straight Shaft Grass Deflector SS30Converting from String Trimmer to Brushcutter BC30 Attaching the Shoulder Harness BC30Converting from Brushcutter to String Trimmer BC30 Removing the TRI-ARCBLADE and Brushcutter GuardGear Head Flanged Washer Slot Installing the TRI-ARCBLADE and Brushcutter GuardOperation Removing the Straight Shaft Grass Deflector and String HeadOperating the Trimmer Fueling and Refueling the TrimmerGrass Deflector Line Trimming CUT-OFF Blade To Advance the Cutting LineTo Advance the Cutting Line Manually Cutting TipsCutting Technique Blade Operating the BrushcutterBlade Thrust TRI-ARCBLADESee Figures 21 Starting and StoppingTo Stop the Engine If Assistance is Required Starting this ProductSee Figures 23 MaintenanceGeneral Maintenance Spool ReplacementSee Figures 25 String ReplacementCleaning the Exhaust Port and Muffler Spark ArrestorStoring the Product Cleaning the AIR Filter ScreenSpark Plug Replacement Fuel CAPTroubleshooting Speed. See FigureFast This Product WAS Manufactured with a Catalyst Muffler WarrantyLimited Warranty Statement MANUFACTURER’S Warranty Coverage California Proposition Parts and Service
Top Page Image Contents