Ryobi CS30 RY30524 manual Starting and Stopping, To Stop the Engine, See Figures 21, For Help Call

Page 18

OPERATION

STARTING AND STOPPING

See Figures 21 - 22.

Trimmer should be on a flat, bare surface for starting. The starting method differs depending on whether the engine is cold or warm.

To start a cold engine:

Slowly press the primer bulb seven (7) times.

Rotate the choke dial clockwise to the FULL CHOKE position.

Squeeze throttle trigger fully and continue to hold through remaining steps.

Pull the starter grip sharply until engine attempts to run (no more than 4 pulls).

Rotate the choke dial counterclockwise to the HALF CHOKE position.

Pull the starter grip sharply until the engine runs.

Allow the engine to run for 10 seconds.

Rotate the choke dial counterclockwise to the RUN position.

To start a warm engine:

Slowly press the primer bulb seven (7) times.

Pull the starter grip sharply until the engine runs.

TO STOP THE ENGINE:

See Figure 21.

Release the throttle trigger and press and hold STOP on the engine switch.

IF ASSISTANCE IS REQUIRED STARTING THIS PRODUCT:

Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have.

For Help Call: 1-800-860-4050

PRIMER

STARTER BULB GRIP

CHOKE DIAL

STARTER

SWITCH

THROTTLE

TRIGGER

Fig. 21

PRIMER BULB

FULL

CHOKE

HALF

CHOKE

RUN

Fig. 22

18

Image 18

Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules Specific Safety Rules for Trimmer USESpecific Safety Rules for BRUSH- Cutter and Blade USE Symbols Symbol Name ExplanationService Symbol Signal MeaningCoupler Throttle Trigger String HeadFeatures CouplerKnob Assembly Attaching the Storage Hanger Installing the Power Head to the AttachmentRemoving the Attachment from the Power Head See FigureFront Handle Bolt Wing NUT Clamp Attaching the Front Handle CS30 and SS30Attaching the J Handle BC30 Flat WasherTo Attach the Straight Shaft Grass Deflector SS30 Attaching the Grass DeflectorTo Attach the Curved Shaft Grass Deflector CS30 Attaching the Brushcutter Guard BC30Removing the TRI-ARCBLADE and Brushcutter Guard Attaching the Shoulder Harness BC30Converting from Brushcutter to String Trimmer BC30 Converting from String Trimmer to Brushcutter BC30Removing the Straight Shaft Grass Deflector and String Head Installing the TRI-ARCBLADE and Brushcutter GuardOperation Gear Head Flanged Washer SlotFueling and Refueling the Trimmer Operating the TrimmerCutting Tips To Advance the Cutting LineTo Advance the Cutting Line Manually Grass Deflector Line Trimming CUT-OFF BladeTRI-ARCBLADE Operating the BrushcutterBlade Thrust Cutting Technique BladeIf Assistance is Required Starting this Product Starting and StoppingTo Stop the Engine See Figures 21Spool Replacement MaintenanceGeneral Maintenance See Figures 23Spark Arrestor String ReplacementCleaning the Exhaust Port and Muffler See Figures 25Fuel CAP Cleaning the AIR Filter ScreenSpark Plug Replacement Storing the ProductTroubleshooting Speed. See FigureFast Warranty This Product WAS Manufactured with a Catalyst MufflerLimited Warranty Statement MANUFACTURER’S Warranty Coverage Parts and Service California Proposition