Ryobi SS30 RY30544, CS30 RY30524, BC30 RY30564 manual Troubleshooting, Speed. See Figure, Fast

Page 22

TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.

PROBLEM

POSSIBLE CAUSE

SOLUTION

 

 

 

Engine will not start

1. No spark.

2. No fuel.

3. Engine is flooded.

1.Check spark. Remove spark plug. Reattach the spark plug cap and lay spark plug on metal cylinder. Pull the rope and watch for spark at spark plug tip. If there is no spark, repeat test with a new spark plug.

2.Push primer bulb until bulb is full of fuel. If bulb does not fill, primary fuel delivery system is blocked. Contact a service dealer. If primer bulb fills, engine may be flooded, proceed to next item.

3.Set the start lever to the START position. Squeeze the trigger and pull the rope repeatedly until the engine starts and runs.

NOTE: Depending on the severity of the flooding, this may require numerous pulls of the rope. See

Figure 23.

Engine does not reach full speed and emits excessive smoke

1.Incorrect oil/fuel mixture.

2.Air filter is dirty.

3.Spark arrestor screen is dirty.

4.Spark plug fouled.

1.Use fresh fuel and the correct 2-cycle oil mix. (50:1).

2.Clean air filter. Refer to Replacing and Cleaning Air Filter earlier in this manual.

3.Contact a servicing dealer.

4.Clean or replace spark plug. Reset spark plug gap. Refer to Spark Plug Replacement earlier in this manual.

Engine starts, runs, and ac-

1.

Idle speed screw on carburetor

1. Turn idle speed screw clockwise to increase idle

 

needs adjustment.

celerates but will not idle

 

 

speed. See Figure 31.

 

 

 

 

 

 

 

 

 

String will not advance

1. String is welded to itself.

1.

Lubricate string with silicone spray.

 

 

2.

Not enough string on spool.

2.

Install more string. Refer to String Replacement

 

 

 

 

 

earlier in this manual.

 

 

3.

String is worn too short.

3.

Pull strings while alternately pressing down on

 

 

 

 

 

and releasing spool retainer.

 

 

4.

String is tangled on spool.

4.

Remove string from spool and rewind. Refer to

 

 

 

 

 

String Replacement earlier in this manual.

 

 

5.

Engine speed is too slow.

5.

Advance string at full throttle.

 

 

 

 

 

 

 

SLOW

 

FAST

IDLE SPEED

Fig. 31

SCREW

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules for Trimmer USE Specific Safety RulesSpecific Safety Rules for BRUSH- Cutter and Blade USE Symbols Symbol Name ExplanationService Symbol Signal MeaningCoupler Throttle Trigger String HeadCoupler FeaturesKnob Assembly Attaching the Storage Hanger Installing the Power Head to the AttachmentRemoving the Attachment from the Power Head See FigureFront Handle Bolt Wing NUT Clamp Attaching the Front Handle CS30 and SS30Attaching the J Handle BC30 Flat WasherTo Attach the Straight Shaft Grass Deflector SS30 Attaching the Grass DeflectorTo Attach the Curved Shaft Grass Deflector CS30 Attaching the Brushcutter Guard BC30Removing the TRI-ARCBLADE and Brushcutter Guard Attaching the Shoulder Harness BC30Converting from Brushcutter to String Trimmer BC30 Converting from String Trimmer to Brushcutter BC30Removing the Straight Shaft Grass Deflector and String Head Installing the TRI-ARCBLADE and Brushcutter GuardOperation Gear Head Flanged Washer SlotFueling and Refueling the Trimmer Operating the TrimmerCutting Tips To Advance the Cutting LineTo Advance the Cutting Line Manually Grass Deflector Line Trimming CUT-OFF BladeTRI-ARCBLADE Operating the BrushcutterBlade Thrust Cutting Technique BladeIf Assistance is Required Starting this Product Starting and StoppingTo Stop the Engine See Figures 21Spool Replacement MaintenanceGeneral Maintenance See Figures 23Spark Arrestor String ReplacementCleaning the Exhaust Port and Muffler See Figures 25Fuel CAP Cleaning the AIR Filter ScreenSpark Plug Replacement Storing the ProductSpeed. See Figure TroubleshootingFast Warranty This Product WAS Manufactured with a Catalyst MufflerLimited Warranty Statement MANUFACTURER’S Warranty Coverage Parts and Service California Proposition
Top Page Image Contents