OPERATING INSTRUCTIONS
DECORATIVE TRIMMING
Decorative trimming is accomplished by removing all vegetation around trees, posts, fences, etc.
Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig. 16).
Fig. 16
MAINTENANCE AND REPAIR INSTRUCTIONS
NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to an authorized service dealer.
MAINTENANCE SCHEDULE
These required maintenance procedures should be performed at the frequency stated in the table. They should also be included as part of any seasonal
WARNING: To prevent serious injury, never do maintenance or repairs with unit running. Always do maintenance and repairs on a cool unit. Disconnect spark plug wire to ensure the unit will not start.
FREQUENCY | MAINTENANCE REQUIRED | REFER TO: | ||
|
|
| ||
Before Starting Engine | Fill fuel tank with fresh fuel | Page 11 | ||
|
| Check oil | Page 19 | |
|
|
| ||
Every 10 Hours | Clean and | Page 20 | ||
|
|
| ||
1st Change at 10 Hours | Change oil | Page 19 | ||
Every 25 | Hours there after | Change oil | ||
Page 19 | ||||
Every 25 | Hours | Clean Spark Arrestor | ||
Page 24 | ||||
|
|
| ||
10 hours on new engine | Check rocker arm to valve clearance and adjust as | Page | ||
|
| required | ||
|
|
| ||
Every 50 | Hours | Check rocker arm to valve clearance and adjust as | Page | |
|
| required | ||
|
|
| ||
Every 50 | Hours | Check spark plug condition and gap | Page 24 | |
|
|
| ||
|
|
|
| |
15