Ryobi 825r manual AIR Filter Maintenance, Cleaning the Air Filter

Page 20

MAINTENANCE AND REPAIR INSTRUCTIONS

AIR FILTER MAINTENANCE

Cleaning the Air Filter

WARNING: To avoid serious personal injury, always turn your trimmer off and allow it to cool before you clean or do any maintenance on it.

Clean and re-oil the air filter every 10 hours of operation. It is an important item to maintain. Not maintaining the air filter will VOID the warranty.

1.Open the air filter cover. Push the tab on the right side of the cover in, pull the air filter cover out and to the left (Fig. 32).

NOTE: It may be necessary to remove the fuel cap to completely remove the air filter cover

2. Remove the air filter (Fig. 32).

Choke Lever

Air Filter

Air Filter Cover

Tab

Fig. 32

3.Wash the filter in detergent and water (Fig. 33). Rinse the filter thoroughly and allow it to dry.

Fig. 33

4.Apply enough clean SAE 30 motor oil to lightly coat the filter (Fig. 34).

Fig. 34

5.Squeeze the filter to spread and remove excess oil (Fig. 35).

Fig. 35

6. Replace the filter (Fig. 36).

NOTE: If the unit is operated without the air filter, you will VOID the warranty.

Back Plate

Choke Lever

Back Plate Slot

Slots

Fig. 36

7.Reinstall the air filter cover. Position the hooks on the left side of the air filter cover into the slots at the left side of the back plate (Fig. 36).

NOTE: It may be necessary to remove the fuel cap to reinstall the air filter cover

8.Swing the cover to the right until the tab on the air filter cover snaps into place in the slot on the back plate (Fig. 36).

9.Replace the fuel cap, if removed.

20

Image 20
Contents OPERATOR’S Manual Table of Contents IntroductionCalifornia Emission Regulations Spark ArrestorSymbol Meaning Safety Warnings for GAS TrimmersRules for Safe Operation Before OperatingOther Safety Warnings While OperatingSafety and International Symbols Symbolmeaning Safety Alert SymbolFor Service INFORMATION, Call Unleaded FuelSharp Blade Choke Control ON/OFF Stop ControlHOT Surface Warning Other optional accessories may be used with the 825r ApplicationsDecorative trimming around trees, fences, etc See list of add-ons onAssembly Instructions Adjusting the J-HANDLEAdding OIL to Crankcase Initial USE OIL and Fuel InformationRecommended OIL Type Using Blended Fuels Using Fuel AdditivesRecommended Fuel Type Fueling UnitSTARTING/STOPPING Instructions Starting InstructionsStopping Instructions Cold Start First Start of the Day or Engine Ran Out of FuelInstalling the Cutting Attachment or Add-Ons Operating InstructionsOperating the CLICK-LINKSYSTEM Removing the Cutting Attachment or Add-OnsTips for Best Trimming Results Adjusting Trimming Line LengthHolding the Trimmer Maintenance and Repair Instructions Maintenance ScheduleFrequency Maintenance Required Refer to Decorative TrimmingLine Installation for the Speedspool Winding the Inner Reel With New LineInstalling a Prewound Reel Releasing the Inner ReelSpeedspool Replacement Parts Cleaning the SpeedspoolChecking the OIL Level Changing the OILAIR Filter Maintenance Cleaning the Air FilterCarburetor Adjustment Clean Air FilterAdjust Idle Speed Screw Check FuelRocker ARM Clearance Remove the rocker arm cover and gasketRocker Arms Adjusting Nuts Feeler Gauge Gasket Replacing the Spark Plug Spark Arrestor MaintenanceACCESSORIES/REPLACEMENT Parts Cleaning and Storage CleaningStorage Long Term StorageT I O N TroubleshootingU S E Specifications EnginePage Owners Warranty Responsibilities Manufacturers Warranty CoverageOPERATOR’S Manual Part no REV. a