Ryobi 825r manual ON/OFF Stop Control, HOT Surface Warning, Sharp Blade Choke Control

Page 7

RULES FOR SAFE OPERATION

SYMBOLMEANING

• THROWN OBJECTS AND ROTATING CUTTER CAN CAUSE SEVERE INJURY

WARNING: Do not operate without the cutting attachment shield in place.

Keep away from the rotating cutting attachment.

•ON/OFF STOP CONTROL

ON / START / RUN

•ON/OFF STOP CONTROL

OFF OR STOP

•HOT SURFACE WARNING

Do not touch a hot muffler or cylinder. You may get burned. These parts get extremely hot from operation. When turned off they remain hot for a short time.

•SHARP BLADE

WARNING: Sharp blade on cutting attachment shield. To prevent serious injury, do not touch line cutting blade.

•CHOKE CONTROL

A • FULL choke position.

B • PARTIAL choke position.

C • RUN position.

WARNING: The operation of any power tool can cause foreign objects to be thrown into your eyes. This can lead to severe eye damage. Before commencing power tool operation, always wear safety glasses or goggles that are marked as meeting ANSI Z87.1-1989 standards, and a full face shield when needed.

Image 7

Contents OPERATOR’S Manual Introduction Table of ContentsSpark Arrestor California Emission RegulationsBefore Operating Symbol MeaningSafety Warnings for GAS Trimmers Rules for Safe OperationWhile Operating Other Safety WarningsUnleaded Fuel Safety and International SymbolsSymbolmeaning Safety Alert Symbol For Service INFORMATION, CallHOT Surface Warning ON/OFF Stop ControlSharp Blade Choke Control See list of add-ons on Other optional accessories may be used with the 825rApplications Decorative trimming around trees, fences, etcAdjusting the J-HANDLE Assembly InstructionsRecommended OIL Type OIL and Fuel InformationAdding OIL to Crankcase Initial USE Fueling Unit Using Blended FuelsUsing Fuel Additives Recommended Fuel TypeCold Start First Start of the Day or Engine Ran Out of Fuel STARTING/STOPPING InstructionsStarting Instructions Stopping InstructionsRemoving the Cutting Attachment or Add-Ons Installing the Cutting Attachment or Add-OnsOperating Instructions Operating the CLICK-LINKSYSTEMHolding the Trimmer Adjusting Trimming Line LengthTips for Best Trimming Results Decorative Trimming Maintenance and Repair InstructionsMaintenance Schedule Frequency Maintenance Required Refer toWinding the Inner Reel With New Line Line Installation for the SpeedspoolReleasing the Inner Reel Installing a Prewound ReelCleaning the Speedspool Speedspool Replacement PartsChanging the OIL Checking the OIL LevelCleaning the Air Filter AIR Filter MaintenanceCheck Fuel Carburetor AdjustmentClean Air Filter Adjust Idle Speed ScrewRemove the rocker arm cover and gasket Rocker ARM ClearanceRocker Arms Adjusting Nuts Feeler Gauge Gasket ACCESSORIES/REPLACEMENT Parts Spark Arrestor MaintenanceReplacing the Spark Plug Long Term Storage Cleaning and StorageCleaning StorageU S E TroubleshootingT I O N Engine SpecificationsPage Manufacturers Warranty Coverage Owners Warranty ResponsibilitiesREV. a OPERATOR’S Manual Part no