Echo SRM-230 specifications Air Filter, Fuel Filter

Page 22

MAINTENANCE

SRM-230

 

 

(2)Apply POWER BLENDXTM grease every 50 hours of use.

(3)Low evaporative fuel tanks DO NOT require regular maintenance to maintain emission integrity.

* Replacement is recommended based on the finding of damage or wear during inspection.

Air Filter

Level 1.

Parts Required: REPOWERTM AIR & FUEL FILTER KIT.

1.Close choke (Cold Start Position [ ]). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from air cleaner area.

2.Remove air filter cover. Brush dirt from inside cover.

3.Replace filter if it is damaged, fuel soaked, very dirty, or the rubber sealing edges are deformed.

• Lightly brush debris from filter.

A

Soak heavily soiled filters in water/detergent solution to loosen dirt, then brush lightly.

Rinse with clean water and allow to dry completely before reuse.

4.Install air filter in air filter case.

5.Install air filter cover.

Fuel Filter

Level 1.

Parts Required: REPOWERTM AIR & FUEL FILTER KIT.

Fuel is VERY flammable. Use extreme care when mixing, storing or handling, or serious personal injury may result.

1.Use a clean rag to remove loose dirt from around fuel cap and empty fuel tank.

2.Use a hook to pull the fuel line and filter from the tank.

3.Remove the filter from the line and install the new filter.

Note: Federal EPA regulations require all model year 2012 and later gasoline powered engines produced for sale in the United States to be equipped with a special low permeation fuel supply hose between the carburetor and fuel tank. When servicing model year 2012 and later equipment, only fuel supply hoses certified by EPA can be used to replace the original equipment supply hose. Fines up to $37,500 may be enforced for using an un-certified replacement part.

22

X7532098207

© 2/2014 ECHO Inc.

Image 22
Contents Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationAdditional or Replacement Manuals SafetyManual Safety Symbols and Important Information International Symbols On / OFFPersonal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment EPA 2010 and Later and/or C.A.R.B. Tier Emission Control Exhaust & EvaporativeProduct Emission Durability Emission Compliance Period Description Description Contents Plastic Shield Installation AssemblyNylon Line Head Installation To Advance Trimmer Line Support Handle InstallationRemove Nylon Line Head Operation Operation With BladesBlade Selection Fuel Requirements FuelHandling Fuel Starting Cold Engine After useStarting Warm Engine Purge BulbMove stop switch button a backward to Stop position Stopping EngineMaintenance Intervals MaintenanceSkill Levels Air Filter Fuel FilterSpark Plug Cooling SystemExhaust System Spark Arrestor ScreenEngine Break-In Carburetor AdjustmentExhaust Port Cleaning High Altitude OperationLubrication Gear HousingDrive Shaft flex cable models Nylon Line Head Disassembly Instructions Nylon Line ReplacementSharpening Metal Blades Maintenance Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage Over 30 DaysSpecifications ModelWarranty Statements OWNER’S ResponsibilityWarranty Statements SRM-230 ECHO, Incorporated