Echo SRM-230 specifications Lubrication, Gear Housing, Drive Shaft flex cable models

Page 26

MAINTENANCE

SRM-230

 

 

1.Check idle speed and reset if necessary. If a tachometer is available, idle speed screw (A) should be set to the specifications found on “Specifications” page of this manual. Turn idle screw (A) clockwise to increase idle speed; counter clockwise to decrease idle speed.

When carburetor adjustment is completed, the cutting attachment should not move at idle, otherwise serious personal injury may result.

A

Lubrication

Level 1.

Parts

POWER BLENDXTM 8 oz. or Lithium Base

Required:

Grease.

Gear Housing

1.Clean all loose debris from gear case.

2.Remove plug (A) and check level of grease.

3.Add grease if necessary. DO NOT over-fill.

Drive Shaft (flex cable models)

B

C A

D

1.Loosen two (2) screws (B) and remove center locating screw (C). Pull gear case and shield from drive shaft housing.

2.Pull flexible cable from the drive shaft housing, wipe clean and re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3.Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.

4.Install the gear housing and shield assembly.

Flat edge of washers (D) must be against drive shaft.

26

X7532098207

© 2/2014 ECHO Inc.

Page 25 Page 27
Image 26
Page 25 Page 27
Contents
Operator’s Manual Burn HazardTable of Contents Introduction Servicing InformationManual Safety Symbols and Important Information SafetyAdditional or Replacement Manuals International Symbols On / OFFPersonal Condition and Safety Equipment Vibration and Cold Repetitive Stress InjuriesEquipment Product Emission Durability Emission Compliance Period Emission Control Exhaust & EvaporativeEPA 2010 and Later and/or C.A.R.B. Tier Description Description Contents Nylon Line Head Installation AssemblyPlastic Shield Installation Remove Nylon Line Head Support Handle InstallationTo Advance Trimmer Line Operation Operation With BladesBlade Selection Handling Fuel FuelFuel Requirements Starting Cold Engine After useStarting Warm Engine Purge BulbMove stop switch button a backward to Stop position Stopping EngineSkill Levels MaintenanceMaintenance Intervals Air Filter Fuel FilterSpark Plug Cooling SystemExhaust System Spark Arrestor ScreenEngine Break-In Carburetor AdjustmentExhaust Port Cleaning High Altitude OperationDrive Shaft flex cable models Gear HousingLubrication Nylon Line Head Disassembly Instructions Nylon Line ReplacementSharpening Metal Blades Maintenance Troubleshooting Engine Problem Troubleshooting ChartStorage Long Term Storage Over 30 DaysSpecifications ModelWarranty Statements OWNER’S ResponsibilityWarranty Statements SRM-230 ECHO, Incorporated
Top Page Image Contents