Black & Decker LST1018 Line Feeding, Replacing SPOOL/CLEARING Jams and Tangled Lines

Page 12

To operate as a maintenanceedger,

 

 

position trimmer above sidewalkas

 

shown in figure P.

 

Return to trimming positionby turning

 

 

the tool off, push in directionof arrow

 

 

and rotating the trimmer head counter

 

 

clockwise until it stops.When using

 

 

the tool in the trimmer mode you may

 

 

choose to fold the wire edge guideup

 

 

out of the way.

 

LINE FEEDING

 

Yourtrimmer uses .065 in. (1.65mm)

 

diameter nylon line to cut grass and weeds quickly and easily. In time,

the tip of the nylon line will become worn and the auto feed

mechanism will automaticallyfeed and trim a fresh length of line.

The cutting line will wear faster if the cutting is done along sidewalks

or other abrasive surfaces or heavier weeds are being cut. The

automatic feed mechanism senses when more cutting line is needed

and feeds and trims the correct length of line whenever it is required.

You donʼt even have to think about it. Do not bump unit on ground in

attempt to feed line or for any other purpose.

REPLACING SPOOL/CLEARING

 

JAMS AND TANGLED LINES

 

From time to time, especially when

RC-100-P

cutting thick or stalky weeds, the line

feeding hub may become clogged with

Cap

sap or other material and the line will

become jammed as a result. Toclear

 

the jam, follow the steps listed below.

 

Turn off the trimmer and removethe

 

battery.

 

Press the release tabs on the line

 

 

spool cover,as shownin figure Q

 

 

and remove the cover by pullingit

 

 

straight off.

12

 

 

Lift the spool of nylon line out of the hub and clear any broken line or

cutting debris from the spool area. In case of jams and tangled line unwrap about one foot (30cm) of line to ensure that it is undamaged. If it is OK rewind it and insert the line end through the eyelet in the

spool hub, as shown in figure R.

 

AF-100 Spool

Pull the line through the hole to

 

maintain tension while placing the

 

spool downintothehub withthe

 

notched sideexposed,as shownin

figure S.

Press the spool down GENTLY

 

and rotate it until you feel it drop

 

into place.(When in place,thespool

 

will turn a few degrees leftandright

freely.)

Snap the spool cover back on,

 

insert the battery and turn the tool

 

on. In a few seconds or less youʼll

 

hear the nylon line being cut

 

automatically to the proper length.

• For trouble free feeding and best results, only use Black & Decker

 

replacement spools with single 0.065 inch line. Black & Decker

 

replacement model number AF-100.

Image 12
Contents Cordless 18 V TRIMMER/EDGER US E Batte RY OP ER Ated UN IT on LY wi th spe cif ica ll y Wear long pants to protect your legs. Wear protective hairCovering to contain long hair Additional Important Safety Instructions Rotating Line Performs a Cutting Function UseKeep Guards in Place and in Working Order Fire hazard. Do not store or carry Do not expose charger to rain or snow Disconnect the charger from the outlet before attempting anyCharge the battery packs only in Black & Decker chargers Never attempt to connect 2 chargers togetherDo not splash or immerse in water or other liquids Storage RecommendationOn/off switch Mode adjustment collarMotor housing Spool housingCharging Procedure 18- 24CFitting and Removing Battery Figure C Assembling and Attaching the TWO PieceGuard To AssembleTo Attach Height Adjustment Base of a chain link fence.Lock-outOperate TRIMMER/EDGER Line Feeding Replacing SPOOL/CLEARING Jams and Tangled LinesRewinding Spool from Bulk Line USE only .065 Diameter LineBattery If your warning labelsProblem Possible Cause Possible Solution Black & Decker U.S. IncLST1018 TAILLE-BORDURE/COUPE Bordure Mode D’EMPLOI Sécurité Générales Pour Tous LES Outils DefinitionsReduction DES Risques ET DES Blessures Utiliser LʼAPPAREIL Fonctionnant SUR Piles uniquementSʼHABILLER DE Manière Appropriée Ne pas porter de Nus ou si vous portez des sandales ouvertes. Porter desLE FIL EN Rotationexécute UNE Coupe Être attentif lors Tenir LES Enfant À LʼÉCART Tous les visiteurs doivent seMicroscopiquesCONSERVER.CES Directives Importantes Directivessupplémentairesde SécuritéConserver CES Directives ce mode dʼemploi comprend Avertissement NE Jamais tenter de relier deux chargeurs ensembleRecommandations dʼentreposage Caractéristiques Probleme Avec LE Secteur BLOC-PILES Laisse Dans LE ChargeurRemarques Importantes Pour LE Chargement IsoléeInstallation ET Retrait DU BLOC-PILES Figure C AssemblageLʼassemblage, retirer la pile de lʼoutil Logement dans lʼoutil. Faire glisser leLanguette Section. Voir lʼencartFonctionnement Mise EN Garde Toujours Porter DES LUN Ettes DE SécuritéMétalliques au pied dʼune clôture à mailles losangées Utilisation DU COUPE-BORDUREAlimentation DU FIL Rebobinage DU FIL EN Vrac Utiliser Seulement DU FIL DE 1,65 mm 0,065 po DE DiamètreAccessoires Entretien800 LE Sceau Rbrcmc Solution possible ProblèmeCause possible LST1018 Si tiene una consulta o algún inconvenientecon su productoGenerales DE Seguridad Para Todas LAS Pautas DE SEGURIDAD/DEFINICIONESPara Reducir EL Riesgo DE Lesiones UNA Unidad Accionada a Bateria con baterías integrales oConserve Estas Instrucciones Instrucciones DE Seguridad Adicionales Importantes Cable ProlongadorSistema de aislamiento no requieren conexión a tierra. Como Voltios Amperios Hertz VatiosTerminal a tierra Símbolo de alerta deNunca intente conectar 2 cargadoresjuntos Baterías puede explotar en el fuegoRecomendación para el almacenamiento Interruptor de Encendido/apagadoBotón de bloqueo Mango principalRemolque sin aislamiento Ensamblado Y Colocacion DEL Protector DE DOS Piezas No congelenisumerja elcargadorenagua nienningúnotrolíquidoColocacion Y Retiro DE LA Bateria Figura C Hasta que encaje en su lugarEnsamblado ColocacionAccesorio DE Mango Auxiliar Ajuste DE AlturaPrecaución Siempre Utilice Proteccion Para LOS OjosAlimentacion DE LA Cuerda Reembobinado DEL Carrete CON Línea a Granel Utilice Únicamente Línea DE 0.065 Pulg .65 mm DEDiámetro Muestra en la Según la hasta que esté Casi llenoFigura. TAccesorios, llame por favor El sello Rbrc Para informarse sobre dónde dejar las baterías, o llame alDetecciondeproblemas Problema Causa posible Solución posibleName · Nombre Page Black & Decker S.A. DE C.V Form No Apr Cat. No. LST1018 Copyright 2010 Black & Decker

LST1018 specifications

The Black & Decker LST1018 is a versatile and efficient cordless string trimmer and edger, designed to make yard maintenance easy and convenient. One of the standout features of this tool is its lightweight design, which allows for easy maneuverability and reduced user fatigue, making it a perfect choice for both beginners and seasoned gardeners. Weighing in at just under 5 pounds, it is easy to handle and can reach those tricky spots in the yard without straining the user.

This model is powered by an 18-volt Lithium-Ion battery, providing ample energy for extended runtime. The battery is interchangeable with other Black & Decker tools in the 18V family, making it a smart investment for those who want multiple tools that share a power source. The lithium-ion technology also ensures that the battery maintains its charge longer, meaning less downtime while trimming and edging.

The LST1018 features a 12-inch cutting width, which enables users to cover more ground in less time. It features a simple push-button feed for the automatic line advancement, allowing for hassle-free operation. This means the user does not have to stop mid-cutting to adjust the line, thus improving efficiency and saving time. The trimmer also has a flip-up edge guide that makes it easy to transition from trimming to edging, offering clean and precise lines.

Ergonomically designed, the LST1018 incorporates a soft-grip handle making it comfortable for prolonged use. The adjustable height and rotating handle further enhance the user experience by allowing personalization to fit individual needs and preferences. Safety features, including a dual-line system, provide better performance and ensure efficient cutting without excessive wear on the line.

The Black & Decker LST1018 is designed not just for efficiency but also for performance. Its powerful motor is capable of handling thick grasses and weeds, making yard maintenance a breeze, regardless of the terrain. With its combination of power, lightweight design, and the convenience of a cordless tool, the LST1018 stands out as a superb choice for homeowners looking to maintain their lawns with minimal effort. This trimmer is ideal for small to medium-sized yards, providing a perfect balance of power and convenience. Whether you are edging along sidewalks or trimming overgrown sections of your garden, the Black & Decker LST1018 promises to deliver highly satisfying results.