Snapper Clean Sweep Twin Catcher manual General Operating Instructions

Page 4

General Operating Instructions

BEFORE OPERATION

Clear the lawn of all sticks, stones, wire and other debris which may be caught or thrown by the mower blades.

Check grass condition. If wet, wait until later in the day. If grass is wet, the grass catcher is likely to become plugged.

For efficient bagging, air circulation under the mower deck, through the chute and into the bag is very important.

For this reason, BEFORE YOU BEGIN MOWING you should make certain the underside of the mower and the underside of the catcher lid are free from grass and debris.

Make sure that there is a snug fit between mower deck, blower housing, tubes, and grass catcher cover.

MOWING WITH THE CATCHER

Always operate with throttle at full speed when mowing.

Grass should be cut often, and not too short. If grass is too long or lush it may be necessary to keep ground speed to a minimum or to cut only half the width of the mower to prevent clogging. If grass is long, operate with mower in high cutting position for first pass, cutting again in a lower position on a second pass.

Do not open the cover with mower engaged.

If a large amount of cut grass is spilling out from under deck, the tube may be plugged or the bags may be full— discontinue mowing, stop the unit, disengage the PTO, shut off the engine and then empty the catcher or clear the tube.

WARNING

ALWAYS shut off the tractor. Disengage the PTO, and allow all moving parts to stop BEFORE disconnecting or clearing tube, or emptying catcher.

Before leaving the operator’s position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.

To reduce fire hazard, keep the engine, rider and mower free of grass, leaves and excess grease. Do not stop or park rider over dry leaves, grass or combustible materials.

CAUTION

Before you begin operating the unit be certain you have read all of the safety and operational information of this instruction sheet, as well as the Operator’s Manual for the tractor and any other attachments.

REQUIRED ACCESSORIES

A front-mounted factory approved weight carrier and 66 lbs. worth of weights are required when using this rear- mounted grass catcher. Never operate on slopes greater than 17.6% (10°).

AFTER OPERATION

CAUTION

Do not leave grass in bagger containers. Empty containers after each use and before storing. Failure to do so may result in spontaneous combustion which could develop into a fire.

Remove any debris from the the screen on the underside of the lid. Note: The lid screen can be partially removed for easier cleaning and should be cleaned regularly.

The blower housing and tube should be removed for cleaning.

Inspect the grass bags for wear or damage. Make sure that there is a snug fit between mower deck, blower housing, tubes, and grass catcher cover.

STORING THE GRASS CATCHER

Clean the grass catcher thoroughly using a mild deter- gent (other products may damage the tube). Remove any debris from the the screen on the underside of the lid.

If paint has been scratched on metal parts, touch up with paint, or apply a thin film of oil to prevent corrosion.

Store in a dry area. Dry thoroughly before storing for a long period of time. Always store away from moisture.

3

Image 4
Contents Clean Sweep Twin Catcher OPERATOR’S ManualTable of Contents Safety Rules Information General WarningsGeneral Operating Instructions Installation Install Deflector Hinge Assembly Install Discharge BaffleDeflector Removal Install Deflector ModelsInstall Turbo Drive Pulley Install Idler Assembly & Belt CoverInstall Anchor Bracket Install Turbo Belt Install Belt Cover PlateInstall Mounting Bracket Install Turbo Drive Belt Install Turbo BlowerSecure Belt Cover Initial Counter Balance & Weight Carrier Installation Counter Balance & Weight Carrier InstallationInitial Hitch & Tube Installation Assemble Tubes & Deflector Assemble Catcher BagsInstall Cover and Bags AssemblyInitial Collector Normal Removal Installation Removing the Grass CatcherInstalling the Grass Carcher Removing and Reattaching Grass CatcherHardware Identification & Torque Specifications

Clean Sweep Twin Catcher specifications

The Snapper Clean Sweep Twin Catcher is a revolutionary lawn care tool designed for homeowners and landscaping professionals alike. This innovative product combines cutting-edge technology with user-friendly features to deliver an exceptional mowing experience. The Twin Catcher is specifically engineered to provide superior grass collection and easy operation, making it a must-have for anyone serious about lawn maintenance.

One of the main features of the Snapper Clean Sweep Twin Catcher is its twin bagging system. This dual-bag design enhances the efficiency of grass collection, allowing users to tackle even the most demanding mowing tasks with ease. Each bag is spacious enough to hold a substantial amount of clippings, minimizing the frequency of stops for emptying. The result is a cleaner lawn and more time spent mowing rather than managing clippings.

Incorporating advanced technology, the Twin Catcher offers an exclusive airflow design that optimizes grass suction. This innovative feature ensures that clippings are collected effectively, reducing lawn debris left behind. The clever design also contributes to preventing clogging, a common issue with traditional mowers, that can disrupt mowing operations and lead to frustration.

Another notable characteristic of the Snapper Clean Sweep Twin Catcher is its durability. The robust construction is built to withstand regular use, ensuring longevity and reliability. Users can trust that this mower will maintain peak performance season after season, even under challenging conditions.

Ease of use is a key consideration in the design of the Snapper Twin Catcher. The mower features an adjustable cutting height, allowing users to customize their mowing experience based on lawn type and desired finish. Additionally, the handle design is ergonomically engineered for comfort, reducing fatigue during longer mowing sessions. The lightweight frame makes maneuvering around obstacles a breeze, enhancing overall productivity.

Lastly, the Snapper Clean Sweep Twin Catcher is compatible with a variety of Snapper mowers, making it a versatile addition to any lawn care arsenal. Whether for small residential lawns or larger properties, this tool is equipped to handle diverse landscaping needs. Overall, the Snapper Clean Sweep Twin Catcher stands out as an exceptional mowing solution, combining high performance, innovative technology, and ease of use to achieve perfect lawn care results.